Datasheet

Charging/recharging the battery
1 Make sure the camera is turned off.
2 Turn on the PC.
3 Connect the USB cable to the USB port of the PC.
4 Connect the camera USB connector to the USB connector on the docking base.
Push it down gently until it clicks in position.
>You will hear a low/high beep, the Charge LED starts blinking blue.
The battery will now be charged.
> The USB LED slowly blinks red.
When USB connection has been established the USB LED remains lit.
> It will take 4 hours to fully recharge the battery.
When the battery is fully recharged the Charge LED will remain lit.
Notes!
– When the battery is fully charged you can take hundreds of photos with the flash and over
thousand photos without the flash.
– When the battery is almost empty, ‘ ‘ appears on the display and the Power low LED starts
blinking.
– The camera contains a lithium-polymer battery.These batteries lose their charge even when not
used, so be sure to charge the battery before taking photos.
–Turn off the camera when you are not using it.
– When the camera is connected to the PC, the camera buttons are disabled.
2.0
MEGA
PIXELS
2.0
MEGA
PIXELS
ENGLISH16