Register your product and get support at www.philips.
Contents 1 Important 2 Safety Notice 2 2 2 Your Docking Speaker 4 4 4 4 3 Get started 5 5 5 6 4 Play 6 6 7 7 5 Product information Specifications 8 8 6 Troubleshooting 8 Introduction What's in the box Overview of the main unit Prepare the docking speaker Connect power Turn on Play from iPod/iPhone/iPad Play from an external device Adjust volume level EN 1
1 Important Warning •• Never remove the casing of this apparatus. •• Never lubricate any part of this apparatus. •• Never place this apparatus on other electrical equipment. Safety •• Keep this apparatus away from direct sunlight, naked flames or heat. •• Make sure that you always have easy access to the power cord, plug, or adaptor to disconnect the apparatus from the power. Important Safety Instructions • • • • • • • • • • • • • 2 Heed all warnings. Follow all instructions.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. iPod is a trademark of Apple Inc., registered in the U.S. and other countries. Note •• The type plate is located on the bottom of the apparatus. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.
2 Your Docking Speaker Overview of the main unit Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. de Introduction With this docking speaker, you can enjoy audio from the iPod/iPhone and other audio devices.
3 Get started Caution •• Use of controls,adjustments,or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. __________________________ Serial No.
Built-in Battery The docking speaker can also operate on builtin rechargeable battery. Battery power Low Medium Full LED indicator Flashing fast Flashing slow Steadily on To recharge the built-in battery: • Connect the unit to the power supply. Note •• Use only the supplied AC adapter to charge the battery. Turn on • Switch on the docking speaker to the ON position. »» The LED indicator turns on.
Load the iPod/iPhone/iPad • Insert your iPod/iPhone/iPad into the dock. Play from an external device You can also listen to an external audio device through this docking speaker. 1 2 Connect the supplied Aux-in link cable to: • the AUX IN jack (3.5mm) on the back of the unit. • the headphone jack on an external device. Start to play on the device (see the device user manual). To remove the iPod/iPhone/iPad • Pull your iPod/iPhone/iPad out of the dock.
5 Product information •• Product information is subject to change without prior notice. Specifications Amplifier 14 W RMS 65 dB 0.8 V RMS 10 kohm General information AC power (power adaptor) Operation Power Consumption Eco Standby Power Consumption Dimensions - Main Unit (W x H x D) Weight- Main Unit 8 EN Warning •• Never remove the casing of this apparatus.
Specifications are subject to change without notice © 2011 Koninklijke Philips Electronics N.V. All rights reserved. DS7700_78_UM_V1.