Always there to help you Register your product and get support at www.philips.
Contents 1 Important 3 2 Your Docking Speaker 4 3 Get started 6 4 Play 8 Introduction What's in the box Overview of the main unit Connect power Turn on Play from iPod/iPhone Play from Bluetooth device Play from an external audio device Adjust volume 4 4 5 6 7 8 8 9 9 5 Product information 10 6 Troubleshooting 11 7 Notice 12 Specifications About Bluetooth device 10 11 EN 2
1 Important • • • • • • • • • 3 Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
2 Your Docking Speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the back of the apparatus. Write the numbers here: Model No. __________________________ Serial No.
Overview of the main unit a d c b e h f a g • Bluetooth Enable or disable Bluetooth function. b Dock for the iPod/iPhone c ON/OFF • Switch on/off the docking speaker. d - VOLUME + • Adjust volume. e DC IN • Connect power. f AUX IN • Connect an external audio device.
3 Get started Option 2: Battery power Caution Always follow the instructions in this chapter in sequence. •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Remove batteries if they are exhausted or will not be used for a long time. Connect power •• Batteries contain chemical substances, so they should be disposed of properly. This docking speaker can be powered by either AC power or batteries.
Turn on Switch the power button to ON position to turn on the docking speaker. »» The LED indicator lights up. Switch to standby mode The docking speaker switches to economic standby mode in the following situation: • The speaker is idle for 15 minutes when powered by AC supply; • The iPod/iPhone or external audio device is disconnected when the speaker is operated on batteries. »» The LED indicator lights off.
4 Play 3 4 Play from iPod/iPhone 5 For first-time use, you will be asked to install DockStudio app on your iPod/ iPhone. Tap [Yes] (yes) to accept the installation request. Follow the on-screen instructions to complete the installation. You can enjoy audio from your iPod/iPhone through this docking speaker. Compatible iPod/iPhone The docking speaker supports the following iPod and iPhone models: Made for.
1 2 Press Bluetooth to select Bluetooth source. »» The Bluetooth button blinks. Turn on Bluetooth function on your device. • Different devices may have different way to activate Bluetooth. To disconnect Bluetooth: • Press Bluetooth on the docking speaker again. • Deactivate Bluetooth function on your device or move it beyond the communication range. Play from an external audio device With this docking speaker, you can also enjoy audio from an external device such as an MP3 player.
5 Product information General information Power supply -AC Power Note •• Product information is subject to change without prior notice. Specifications Amplifier Total Output Power Signal to Noise Ratio MP3 Link 2 x 5 W RMS >60 dBA 0.6 V RMS 22 kohm -Battery power Operation Power Consumption Eco Standby Power Consumption Max.
6 Troubleshooting Warning •• Never remove the casing of this device. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www.philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.
7 Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone respectively, and has been certified by the developer to meet Apple performance standards.
Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N.V. All rights reserved. DS7530_05_UM_V2.1 _ Year 2012 ......................................................................................... (Year in which the CE mark is affixed / Année au cours de laquelle le marquage CE a été apposé) DS7530/05, /12 .............................................
