User manual

ManualsBrandsPhilips ManualsDocking StationDS3600/85

www.philips.com/welcome

DS3600

Always there to help you

User Manual

Question?

Contact

Philips

Summary of content (14 pages)

PAGE 1
Always there to help you Register your product and get support at www.philips.
PAGE 2
Contents 1 Important Safety 3 3 2 Your Docking Speaker 4 3 Get started 6 4 Play 7 Introduction What's in the box Overview of the main unit Overview of the remote control Prepare the remote control Connect power Turn on Play from iPod/iPhone/iPad Play from Bluetooth devices Play from an external audio device Adjust volume Mute sound 4 4 5 6 6 6 7 7 9 10 10 10 5 Product information 11 6 Troubleshooting 11 7 Notice 12 Specifications About Bluetooth device Disposal of your old product and
PAGE 3
1 Important h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Safety i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Know these safety symbols j Only use attachments/accessories specified by the manufacturer.
PAGE 4
information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org. q Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the disconnect device shall remain readily operable. Warning •• Keep the battery away from heat, sunshine or fire. Never discard battery in fire. •• Replace the battery with the same or equivalent type only. •• The battery contains chemical substances, so it should be disposed of properly.
PAGE 5
Overview of the main unit c a b d f e a Dock for the iPod/iPhone/iPad b c 5 • • / • • • EN Adjust volume. As LED indicators, show system status. Select Bluetooth mode. Turn the docking speaker on. Switch to standby mode. d Power supply socket • Connect AC power. e • Sync with PC through a USB cable. f MP3-LINK • Connect an external audio device.
PAGE 6
3 Get started Overview of the remote control Always follow the instructions in this chapter in sequence. f a e b Prepare the remote control d For first-time use: Remove the protective tab to activate the remote control battery. c To replace the exhausted battery: 1 2 3 Open the battery tray. Insert one CR2025 battery with correct polarity (+/-) as indicated. Close the battery tray. CR2025 a b c d e f • • • Select iPod/iPhone/iPad dock mode. / Skip to a track. Search within play.
PAGE 7
4 Play Play from iPod/iPhone/iPad You can enjoy audio from iPod/iPhone/iPad through this docking speaker. Turn on Press and hold on the main unit for 2 seconds. »» The / LED indicators light up. Switch to standby mode In the following situation, the docking speaker switches to standby mode: • Press and hold for 2 seconds again; or • The system is idle for 15 minutes. »» In standby mode, the LED indicators light off.
PAGE 8
• • • To pause or resume play, press . To skip to a track, press / . To search during play, press and hold then release to resume normal play. / , Update firmware If firmware update is available, the DockStudio app will search for it automatically and ask you to download it. Note •• Make sure that your iPod/iPhone/iPad is inserted in the docking speaker and connected to the Internet. 2 3 4 5 6 For first-time use, you will be asked to install DockStudio app on your iPod/ iPhone/iPad.
PAGE 9
2 Follow the on-screen instructions to complete the firmware update. Sync iPod/iPhone/iPad with PC Note •• Make sure that iTunes has been configured properly in your PC. 1 2 3 4 Insert the iPod/iPhone/iPad in the dock. Press and hold for 2 seconds to switch the docking speaker to standby mode. »» The LED indicators light off. Connect your docking speaker and PC with a USB cable. Launch iTunes to synchronize your docking speaker with PC.
PAGE 10
2 Turn on Bluetooth function on your device. • Different devices may have different way to activate Bluetooth. Play from an external audio device 1 2 If no iPod/iPhone/iPad is docked, connect an MP3 link cable (3.5mm, not supplied) to: • the MP3-LINK socket at the back of the docking speaker. • the headphone socket on an external device. »» The docking speaker switches to MP3 link mode automatically. Play music on the device (see the device's user manual).
PAGE 11
5 Product information •• Product information is subject to change without prior notice. Specifications Amplifier 2 X 10 W RMS > 57 dBA 500mV RMS Bluetooth Standard Output power Frequency band Range Bluetooth Standard Version 2.1+EDR 0 dBm (Class 2) 2.402~2.480 GHzISM Band 10m (free space) General information AC Power Operation Power Consumption Standby Power Consumption Max.
PAGE 12
About Bluetooth device Music playback is unavailable on the system even after successful Bluetooth connection. •• The device cannot be used with the system to play music. The audio quality is poor after connection with a Bluetooth-enabled device. •• The Bluetooth reception is poor. Move the device closer to the system or remove any obstacle between the device and the system. Cannot connect with the system. •• The device does not support the profiles required for the system.
PAGE 13
negative consequences on the environment and human health. Please visit www.recycle.philips.com for additional information on a recycling center in your area. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company.