Technical data

Advanced settings 33
7.9 Unregister
Press
m key in idle mode, scroll
: to ADVANCE SET and press
m OK , scroll : to UNREGISTER
and press m OK .
Enter the Master PIN when prompted
and press
m OK to confirm.
Note
By default, the Master PIN is 0000.
Scroll
: to select the handset
number to unregister and press
m OK .
• A validation tone is emitted to indicate
successful unregistration and the
screen shows
UNREGISTERED .
Note
If no action is taken on the handset within
15 seconds, the unregistration procedure
will be aborted and the handset returns
to idle mode.
To unregister a handset that does not
belong to the DCTG240/245 range, you
can only use the DCTG240/245 handset
to unregister it.
7.10 Change Master PIN
The Master PIN is used for setting call
barring/baby call number, registration/
unregistration of handsets and for
accessing the answering machine
remotely. The default Master PIN
number is 0000. The maximum length of
the Master PIN is 8 digits. This PIN is also
used to protect the settings of your
handset. Your handset will prompt you
whenever the PIN is required.
Note
The default pin code is preset to 0000. If
you change this PIN code, keep the PIN
details in a safe place where you have easy
access to them. Do not lose the PIN
code.
Press
m key in idle mode, scroll
: to ADVANCE SET and press
m OK , scroll : to PIN and press
m OK .
Enter the current Master PIN when
prompted and press
m OK to
confirm.
• The PIN entered will be shown as
asterisks (*) on the screen.
Enter the new PIN and press
m OK
to confirm PIN change.
Tip
If you forget your PIN, you will need to
reset your phone to its default settings.
See next section “Reset Unit” for more
details.
7.11 Reset Unit
You can reset your phone to its default
settings with this feature.
Warning
Upon reset, all your personal settings, call
log and redial list entries will be deleted
and the phone will return to its default
settings. However, your phonebook will
remain unchanged after reset.
Note
You may have to configure your phone
once again. In this case the WELCOME
mode will appear again after master reset.
(go to chapter 3.3)
1
2
3
1
2
3
!
DCTG245_IFU_EN_for_India.book Page 33 Wednesday, August 1, 2007 12:39 PM