Quick start guide

AC power adaptor
MW loop
antenna
FM wire antenna
Connect the MW and FM antennas.
Connect the AC power adaptor of the system.
1
2
Tip
– See the User Manual for how to
connect other equipment to this system.
– Use the supplied AC power adaptor
only! Using any other power connection
device may damage your main set!
2
1
Setting the clock
1
2
3
In standby mode, press PROG.
➜ SET CLOCK is displayed briefly. Then, 12HR or 24HR is displayed.
Press ALBUM/PRESET +/- (or ¡ / ™ on the remote control) to select
clock mode.
➜ The clock digits for the hours continue to flash.
Press ALBUM/PRESET +/- (or ¡ / ™ on the remote control) to set the
hours.
Press PROG again.
➜ The clock digits for the minutes flash.
Press ALBUM/PRESET +/- (or ¡ / ™ on the remote control) to set the
minutes.
Press PROG to confirm the time.
4
5
6
TIMER
iPod
DCM230 QUGG_Eng 8/29/08, 16:322