Register your product and get support at www.philips.
Contents 1 Important Safety Notice 2 Your Micro Music System Introduction What’s in the box Overview of the main unit Overview of the remote control 3 Get started Connect speakers Connect FM aerial Connect power Prepare the remote control Turn on Set clock Demonstrate the features Store radio stations automatically 4 Play Basic play operations Play from disc Play from USB Adjust sound 5 Play from iPod/iPhone/iPad compatible iPod/iPhone/iPad Load the iPod/iPhone/iPad Charge the iPod/iPhone/iPad List
1 Important • Safety • • • • This ‘bolt of lightning’ indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering. The ‘exclamation point’ calls attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems.
Warning •• Never remove the casing of this device. •• Never lubricate any part of this device. •• Never place this device on other electrical equipment. •• Keep this device away from direct sunlight, naked flames or heat. •• Ensure that you always have easy access to the power cord, plug, or adapter to disconnect the device from the power. Hearing safety Listen at a moderate volume. • Using headphones at a high volume can impair your hearing.
When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health.
2 Your Micro Music System Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
Overview of the main unit a o b n c d e f m g h l i a Dock for iPod/iPhone/iPad b Disc compartment • Hold the disc. c • USB socket. d MP3 LINK • Connect external audio device. e f 8 • Headphone socket. • • Turn on the unit. Switch to standby or Eco power standby mode. EN j k g IR sensor • Detect signals from the remote control (always point the remote control towards the IR sensor). h SOURCE • Select a source. i j k • • • / Skip to previous/next track. Search within a track/disc.
l - PRESET/ALBUM+ • Skip to previous/next album. • Select a preset radio station. • Navigate through iPod/iPhone/iPad menu. m Display panel • Display current status. n • Open or close the disc tray. o VOLUME • Adjust volume. • Adjust time.
b • Mute/restore volume. c CD • Select CD source. d / • • • Skip to previous/next track. Search within a track/disc. Tune to a radio station. e MP3 LINK/USB • Select MP3 LINK or USB source. f RDS/DISPLAY • For selected FM radio stations: display RDS information. • Synchronize clock with RDS station. • Display play information. g • Start or pause play. h VOL +/• Adjust volume. i Numeric keypad • Select a track directly. j PROG/CLOCK SET • Program tracks. • Program radio stations. • Set clock.
3 Get started Connect FM aerial Tip Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. __________________________ Serial No.
Prepare the remote control Caution •• Risk of explosion! Keep batteries away from heat, sunshine, or fire. Never discard batteries in fire. To insert the remote control battery: 1 2 3 Open the battery compartment. Insert 2 AAA batteries with correct polarity (+/-) as indicated. Close the battery compartment. a Turn on Press . »» The unit switches to the last selected source. Switch to standby mode Press again to switch the unit to standby mode. »» The clock (if set) is displayed.
5 Press PROG/CLOCK SET to confirm the clock setting. Note •• To exit clock setting mode without storing, press . •• If no button is pressed in 90 seconds, the system exits clock setting mode automatically. Demonstrate the features In the standby mode, press until [DEMO ON] (demo on) is displayed. »» The features of this micro system are displayed one by one. • To turn off the demonstration, press again.
Play from USB Note •• Ensure that the USB device contains playable audio contents for supported formats. 1 2 Insert a USB device into the USB socket. Press USB to select the USB source. »» Play starts automatically. • 14 EN If not, press PRESET/ALBUM to select a folder and / to select a file, and then press OK to start play. Adjust sound During play, you can adjust volume through following operations. Key VOL +/DBB DSC Function To increase/decrease the volume. To mute/restore sound.
5 Play from iPod/ iPhone/iPad When the iPod/iPhone/iPad is docked on this Micro System, you can listen to music from the speakers. Load the iPod/iPhone/iPad 1 2 Push the lock key to open the lid of the dock. Insert your iPod/iPhone/iPad onto the dock. Note •• No audio output from the headphone jack in this situation.
Install the rubber pad Note •• If your iPad 2 is not in case, you need to use the supplied rubber pad to keep it stable. 1 2 Open the dock, and place the rubber pad onto the dock compartment as indicated. Load your iPad 2. Charge the iPod/iPhone/iPad When the unit is connected to power, the docked iPod/iPhone/iPad starts charging automatically.. Note •• iPod with color display, iPod classic, and iPod with video are not compatible with dock charging.
6 Listen to FM radio Tune to FM radio stations Note •• Ensure that you have connected and fully extended the supplied FM antenna. 1 2 3 4 Press FM. Program radio stations manually Note •• You can program a maximum of 20 preset radio stations. 1 2 3 Press and hold / for more than two seconds to tune to a radio station. When the frequency starts to change, release the button. »» The FM tuner tunes to a station with strong reception automatically. Repeat steps 2-3 to tune to more stations.
Show RDS information Radio Data System (RDS) is a service that allows FM stations to show additional information. If you tune to an RDS station, an RDS icon and the station name are displayed. 1 2 Tune to an RDS station. Press RDS repeatedly to scroll through the following information (if available): »» Station name 7 Other features Set sleep timer When the unit is turned on, press SLEEP/TIMER repeatedly to select a time period (in minutes). »» When sleep timer is activated, is displayed.
4 5 6 Press / repeatedly to set hour, and then press SLEEP/TIMER. »» The minute digits are displayed and begin to blink. Press / to set minute, and then press SLEEP/TIMER again. »» VOL (volume) is displayed and begins to blink. Press / to adjust volume, and then press SLEEP/TIMER to confirm. »» is displayed. Activate/deactivate alarm timer In standby mode, press SLEEP/TIMER repeatedly to activate or deactivate the timer. »» If timer is activated, is displayed.
8 Product information Note •• Product information is subject to change without prior notice. Amplifier 2 x 10 W RMS 40 Hz-20 kHZ, ±3 dB > 77 dB 600 mV RMS 22 kohm Disc Laser Type Disc Diameter Support Disc Audio DAC Total Harmonic Distortion Frequency Response S/N Ratio Tuning Range Tuning grid Sensitivity - Mono, 26dB S/N Ratio - Stereo, 46dB S/N Ratio Search Selectivity Total Harmonic Distortion Signal to Noise Ratio 87.
• memory cards (requires an additional card reader to work with this unit) Supported formats: • USB or memory file format FAT12, FAT16, FAT32 (sector size: 512 bytes) • MP3 bit rate (data rate): 32-320 Kbps and variable bit rate • WMA v9 or earlier • Directory nesting up to a maximum of 8 levels • Number of albums/ folders: maximum 99 • Number of tracks/titles: maximum 999 • ID3 tag v2.
•• •• •• Insert the battery with its polarities (+/– signs) aligned as indicated. Replace the battery. Aim the remote control directly at the sensor on the front of the unit. No disc detected •• Insert a disc. •• Check if the disc is inserted upside down. •• Wait until the moisture condensation at the lens has cleared. •• Replace or clean the disc. •• Use a finalized CD or correct format disc.
© 2012 Koninklijke Philips Electronics N.V. All rights reserved. DCM2020_UM_05_V3.
