Register your product and get support at www.philips.
Contents 1 Important Safety Notice 2 Your Micro Music System Introduction What's in the box Overview of the main unit Overview of the remote control 3 Get started Prepare the remote control Connect speakers Connect power Auto install radio stations Set clock Demonstrate features Turn on 4 Play Play disc Play from USB Adjust sound Basic play operations 5 Play iPod/iPhone Compatible iPod/iPhone Load the iPod/iPhone Charge the iPod/iPhone Listen to the iPod/iPhone Remove the iPod/iPhone 6 Listen to radio
1 Important Safety f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or produce heat. i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
n Battery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: & Install all batteries correctly, + and - as marked on the unit. & Do not mix batteries (old and new or carbon and alkaline, etc.). & Remove batteries when the unit is not used for a long time. & Batteries (battery pack or batteries installed) shall not be exposed to * ; % the like. o Apparatus shall not be exposed to dripping or splashing.
Notice ? @ device that are not expressly approved by Philips Consumer Lifestyle may void the user’s ? $ < This product complies with the radio $ J Community. Your product is designed and manufactured # @ $ ? % which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/EC.
This apparatus includes this label: Note 2 Your Micro Music System Congratulations on your purchase, and # Q V ? ! support that Philips offers, register your product at www.philips.com/welcome. & The type plate is located on the bottom of the apparatus.
What's in the box Check and identify the contents of your package: & Main unit & 2 x Speakers & Power cord & Remote control with 2 AAA batteries & User manual & Quick start guide Overview of the main unit m a l b c d k j i h e f g a & Open or close the disc compartment. b SOURCE & Select a source: Disc, USB, tuner, Dock, or MP3 link. c DBB & Turn the dynamic bass enhancement on or off. 8 EN d VOL +/& Adjust volume. & Adjust time. e & Start or pause play.
g & Stop play or erase a program. h MP3-LINK & Connector (3.5mm) for an external audio device. Overview of the remote control i iR sensor & Detect signals from the remote control (always point the remote control towards the iR sensor). a j c & Turn on the unit, or switch to standby mode, or switch to Eco Power standby mode. b CD s r FM PRESET/ALBUM q d k & Connector for a USB device. l Display panel & Show current status.
c CD & Select disc source. d & & & / Skip to the previous/next track. Search within a track. Tune to a radio station. e MP3 LINK / USB & Select USB device source. & Select external audio device source. f DISPLAY & Select display information during play. g & Start or pause play. h VOL -/+ & Adjust volume. & Adjust time. i Numeric keypad & Select a track from a disc directly. j PROG/CLOCK SET & Set the clock. & Program tracks. & Program radio stations. k SLEEP/TIMER & Set the sleep timer.
3 Get started Connect speakers Note Caution & Use of controls or adjustments or performance of & For optimal sound, use the supplied speakers only. & Connect only speakers with impedance that is the procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in $ < If you contact Philips, you will be asked for the model and serial number of this apparatus.
4 Press / or VOL -/+ to select 12 hour or 24 hour format. 5 Press PROG/CLOCK SET. » The hour digits begin to blink. 6 7 Press 8 9 Press 1 Connect the unit to the power supply. » [AUTO INSTALL - PRESS PLAYSTOP CANCEL] (press to start automatic installation, or press to cancel) is displayed. 2 Press on the main unit to start installation.
Turn on 4 Play Press . » The unit switches to the last selected source. Play disc Switch to standby When the unit is turned on, press to switch the unit to standby. & In standby, press and hold over three seconds to switch from normal standby to Eco power standby or vice versa. » In normal standby, the clock (if set) appears on the display panel. 1 2 Press CD to select the disc source. 3 Insert a disc with the printed side facing outward, and then press to close the disc compartment.
REPEAT/SHUFFLE Adjust sound During play, you can adjust volume through following operations. Key VOL +/DBB DSC Function To increase/decrease the volume. To mute/restore sound. To turn on or off dynamic bass enhancement. If DBB is activated, [DBB] is displayed. To select your desired sound effect: [POP] (pop) [JAZZ] (jazz) [ROCK] (rock) [CLASSIC] (classic) [FLAT] \= ] To select a repeat play mode: : play current track repeatedly. : play all tracks repeatedly. : the current album is played repeatedly.
5 Play iPod/iPhone ? $ # Q ^ iPhone. You can enjoy audio from the docked system through the powerful speakers. Charge the iPod/iPhone When the unit is connected to power, the docked iPod/iPhone starts charging automatically. Note Compatible iPod/iPhone & iPod with color display, iPod classic, and iPod with video are not compatible with dock charging.
6 Listen to radio Program radio stations manually Note & You can program a maximum of 20 preset radio Tune to a radio station 1 2 stations. Press FM. Press and hold / over two seconds. » [SEARCH] (search) is displayed. » The radio tunes to a station with strong reception automatically. 3 Repeat step 2 to tune to more stations. & To tune to a weak station, press / ? ? optimal reception. & ; $ ?% OK on remote control repeatedly to select stereo or mono sound.
7 Other features Activate/deactivate alarm timer In standby mode, press SLEEP/TIMER repeatedly to activate or deactivate timer. » If timer is activated, is displayed. Set the timer This unit can be used as a timer. The disc/tuner/ USB/dock is activated to play at a preset time. Note & Make sure that you have set the clock correctly. 1 In standby mode, press and hold SLEEP/ TIMER until [TIMER SET] (timer set) scrolls on the display. » !"#$#%& "() %#* scrolls on the display.
Play from an external device You can also listen to an external audio device through this unit. 1 Press MP3 LINK to select the MP3 link source. 2 Connect an MP3 link cable to: & the MP3 LINK connector (3.5mm) on the unit. & the headphone connector on an external device. 3 Start to play the device (see user manual of the device). Headphone Plug headphones (not supplied) into the connector on the unit to listen through the headphones.
Tuner Tuning Range Tuning grid FM sensitivity - Mono Total Harmonic Distortion Signal to Noise Ratio Number of presets FM: 87.5 - 108 MHz 50 KHz 26 dB <2% >55 dB 20 (FM) Speakers Speaker Impedance Speaker Driver Sensitivity 4 ohm 2 X 3" full range >82 dB/m/W USB playability information Compatible USB storage devices: & > = ? \ > < USB1.1) & > = ? \ > < > < ] & ? \ $ card reader to work with this system) Supported formats: & > ?
9 Troubleshooting Warning & Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before $ @ ; < ! unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N.V. All rights reserved. DCM1070_05_UM_V1.
