Always there to help you Register your product and get support at www.philips.
(in standby mode) (in standby mode)
1 2 3 4 5 6 7 Important 4 8 Your Micro Hi-Fi System 7 9 Safety Notice Introduction What’s in the box Overview of the main unit Overview of the remote control 4 5 7 7 8 9 Preparations 11 Get started 14 Play 15 Play from iPod/iPhone/iPad 17 Listen to radio 18 Place the product 11 Connect 11 Install/replace the batteries of remote control 13 Turn on Set clock Demonstrate features Adjust brightness of display panel Turn on or off LED light Play a disc Play from a USB storage device
1 Important Read and understand all instructions before you use this product. If damage is caused by failure to follow the instructions, the warranty does not apply. Important notes for users in the U.K. Mains fuse This information applies only to products with a UK mains plug. This product is fitted with an approved nonmolded plug. If you replace the fuse, use one with: • the ratings shown on the plug, • a BS 1362 approval, and • the ASTA approval mark.
Risk of contamination! • Do not mix batteries (old and new or carbon and alkaline, etc.). • Remove batteries if they are exhausted or if the remote control is not to be used for a long time. • Batteries contain chemical substances, they should be disposed of properly. Risk of swallowing coin battery! • The device may contain a coin/button type battery, which can potentially be swallowed. Keep the battery out of reach of children at all times! If swallowed, the battery can cause serious injury or death.
Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste.
Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.Philips.com/welcome.
Overview of the main unit a b i c j d k e f l g m h n a Dock for iPod, iPhone and iPad b • / • Skip to the previous/next track, title, or file. Select a programmed radio station. c SOURCE • Select a source. d e • • • • • f 8 • EN Turn on this product. Switch to the eco-power standby mode or normal standby mode. /OK Start, pause, or resume the play. In the DAB or FM mode, confirm the menu option.
m Display panel a • • b DIM • Adjust the brightness of display panel. • Press and hold to turn on or off the LED light at the bottom of the unit and at the volume knob. n Disc compartment Overview of the remote control a y b c SCAN • Search for available FM or DAB radio stations. d SLEEP • Set the sleep timer. e x c • w v d • • u e t s f g r h q p o i j k In the DAB/FM mode, navigate through the menu. : Skip to the previous/next album.
i • • • • / Search backward or forward fast. Tune to an FM radio station. Select the previous/next stored DAB radio station. In the DAB or FM mode, navigate through the menu. j TREBLE • Activate the adjustment of treble level. k BASS • Activate the adjustment of bass level. l Numeric keypad • Enter numbers. • Enter the track number to select a track directly. • Enter the sequence number to select a programmed radio station.
Place the product Connect speakers English 3 Preparations Note • Insert the stripped portion of each speaker wire into the socket completely. • For the optimal sound, use the supplied speakers only. • Connect speakers only with impedance that is the same or higher than that of the supplied speakers. Two speaker cables are supplied. Each speaker cable has two branches.
Connect the DAB/FM antenna Tip • Make sure that you have connected and fully extended the antenna before your connect the power supply. • For better reception, connect an outdoor FM antenna to the DAB/FM AERIAL socket. • The unit does not support MW radio reception. Route audio from other devices Press MP3-LINK/AUX to select the audio input through the MP3-LINK socket or the AUX IN L/R sockets.
Connect power English a Caution • Risk of product damage! Make sure that the power • supply voltage corresponds to the voltage printed on the back or the underside of the unit. Before you connect the AC power cord, make sure that you have completed all other connections. b c Connect the AC power cord to: • the AC MAINS~ socket on this product. • the wall power socket. Install/replace the batteries of remote control 1 2 3 Press and push the battery compartment to slide it open.
4 Get started Set clock 1 Caution • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Turn on Press . » This product switches to the last selected source. Switch modes Automatically switch the modes: • After this product keeps inactive for 15 minutes, it automatically switches to the normal standby mode.
Press DIM repeatedly to select different brightness levels. Turn on or off LED light In the working mode, press and hold DIM to turn on or off the LED light at the bottom of the unit and at the volume knob. 5 Play English Adjust brightness of display panel Play a disc Caution • Risk of damage to the player! During play, never move the unit. • Never put any object other than a disc into the disc compartment. • Never look at the laser beam inside the player.
Program audio tracks 1 2 Make sure that the USB storage device contains playable audio contents. 1 Insert the USB storage device into the (USB) socket. 2 Press USB to select the USB source. » Play starts automatically. If the play does not start automatically, 1 2 3 Press ALBUM/ Press Press / to select a folder. 3 4 5 6 Press to stop the play. Press PROGRAM. » [PRG] blinks on the display panel. Press / to select a track number. Press PROGRAM. Repeat steps 3 and 4 to program more tracks.
Load the iPod/iPhone/iPad English 6 Play from iPod/ iPhone/iPad You can enjoy audio from iPod/iPhone/iPad through this unit. Note • No audio output from the headphone jack in this situation. Compatible iPod/iPhone/iPad The unit supports the following iPod, iPhone and iPad models.
Charge the iPod/iPhone/iPad 7 Listen to radio The docked iPod/iPhone/iPad begins to charge as soon as this product is connected to AC power. Note • iPod with color display, iPod classic, and iPod with video are not compatible with dock charging. Note • Make sure that you have correctly connected and fully extended the antenna. • You can program a maximum of 30 DAB radio stations and 30 FM radio stations. • Check with local retailer or go to www.WorldDAB.
1 2 » DAB mode: [STATION] is displayed. Press / or / to select a menu option, and then press OK or to confirm the option or enter the lower-level menu. FM mode [SCAN SETTINGS] [AUDIO] [SYSTEM] DAB mode [STATION] [FULL SCAN] [MANUAL] [DRC] [SYSTEM] Use the menu When you listen to radio, you can access the menu for control options. Press MENU or . » FM mode: [SCAN SETTINGS] is displayed.
8 Other features Set the alarm timer You can use this product as an alarm clock. You can select CD, USB, Dock, iPod/iPhone/iPad playlist, FM, or DAB as the alarm source. 1 2 3 4 5 6 7 Make sure that you have set the clock correctly. In the normal standby mode, press and hold TIMER until [TIMER SET] scrolls on the display. Press VOL +/- to select an alarm source: CD, FM, DAB, USB, Dock, or iPod/iPhone/ iPad playlist.
Check the current firmware version English 9 Upgrade the firmware Follow the steps to check the current version of firmware on your product. Note • Power supply must not be interrupted during the • • upgrade. The firmware upgrade can only be available through the mini-USB port on the back plate. When the firmware upgrade succeeds, all settings are restored to the factory default status. 1 2 3 4 5 6 Register your product 1 2 3 4 5 6 Go to www.philips.com/welcome.
10 Product information Note • Product information is subject to change without prior notice. Amplifier 2 X 50W RMS 20 - 20000 Hz, ±3dB >82dBA 1000 mV RMS 22kohm Disc Laser Type Disc Diameter Support Disc Semiconductor 12cm/8cm CD-DA, CD-R, CD-RW, MP3-CD, WMA-CD 24Bits / 44.1kHz Audio DAC Total Harmonic Distortion <0.8% (1kHz) Frequency Response 4Hz -20kHz (44.
Compatible USB devices: • USB flash memory (USB 2.0 or USB1.1) • USB flash players (USB 2.0 or USB1.1) • memory cards (requires an additional card reader to work with this unit) Supported formats: • USB or memory file format FAT12, FAT16, FAT32 (sector size: 512 bytes) • MP3 bit rate (data rate): 32-320 Kbps and variable bit rate • WMA v9 or earlier • Directory nesting up to a maximum of 8 levels • Number of albums/ folders: maximum 99 • Number of tracks/titles: maximum 999 • ID3 tag v2.
11 Troubleshooting Warning • Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
© 2012 Koninklijke Philips Electronics N.V. All rights reserved. DCB7005_10_UM_V3.
