Always there to help you Register your product and get support at www.philips.
Contents 1 Safety 2 2 2 3 2 Your micro music system 4 4 4 4 5 Know these safety symbols Important safety instructions Hearing safety Introduction What's in the box Overview of the main unit Overview of the remote control 3 Before use 7 7 7 8 4 Get started 8 8 9 9 9 Connect the radio antenna Connect power Install the remote control battery Turn on Set the clock Select a source Adjust the brightness of LCD display 5 Play from hard media Play a disc Play from a USB storage device Control play Progra
1 Safety Read and understand all instructions before you use this micro music system. If damage is caused by failure to follow the instructions, the warranty does not apply. Know these safety symbols • • • • • This 'bolt of lightning' indicates uninsulated material within your unit may cause an electric shock. For the safety of everyone in your household, please do not remove product covering.
Risk of overheating! • Never install this product in a confined space. Always leave a space of at least four inches around the product for ventilation. • Make sure that curtains or other objects never cover the ventilation slots on the product. Risk of contamination! • Remove the battery if it is exhausted or if the remote control is not to be used for an extended period of time. • Batteries contain chemical substances, they should be disposed of properly.
2 Your micro music system Always there to help you Always there to help you Register your product and get support at www.philips.com/welcome Register your product and get support at DCM2260 www.philips.com/welcome Question? Contact Philips Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
d e • • Stop the play of music. Access the playlist of a docked iPod/ iPhone. • Connect a compatible USB storage device for music play. Connect a compatible USB device for charging. • f Disc compartment g h • • • • Press to eject the disc from the disc compartment. / Skip to the previous or next track. Press and hold to search within a track. Tune to a radio station. i VOL+/VOL• Increase or decrease the volume level. j Dock for iPod/iPhone/iPad • Connect to a compatible iPod/iPhone/ iPad.
c DOCK/ CD • Switch the source to the connected iPod/iPhone/iPad or the disc in the disc compartment. n PROG • Program radio stations. • Program tracks that are stored on a disc or USB storage device. d FM/DAB • Switch the source to FM tuner or DAB tuner. o DISPLAY/RDS • In working mode, press to toggle through available information. • In normal standby mode, press and hold to adjust the brightness of LCD display. e PRESET/ALBUM / • Skip to the previous or next album. • Select a preset radio station.
3 Before use Connect the radio antenna Note •• For optimal reception, fully extend the antenna and adjust its position, or connect an outdoor antenna. •• This product does not support AM (amplitude modulation) radio reception. 2 Connect the AC power adaptor to • the DC IN socket on the back panel, and • the wall outlet. Connect the radio antenna to the product.
Install the remote control battery a c 4 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. b Always follow the instructions in this chapter in sequence. 1 2 3 Open the battery compartment. Insert one AAA battery with correct polarity (+/-) as indicated. Close the battery compartment. Turn on Press . »» This product switches to the last selected source.
• Press to switch this product • between the working mode and the normal standby mode, or • from the eco power standby mode to the working mode. Set the clock Note •• During setting, if no action is made within 90 seconds, the product exits clock setting without saving earlier operations. 1 2 3 4 5 In standby mode, press and hold CLOCK to enter the clock setting mode. »» or is displayed. Press + VOL - or / to select or , and then press CLOCK.
5 Play from hard media Play a disc Note • Note •• WOOX Innovations does not guarantee compatibility with all USB storage devices. •• FAT16 and FAT 32 file systems are supported, and NTFS (New Technology File System) not. •• Make sure that the disc contains playable audio content. 1 2 Press CD or SOURCE to switch the source to . Insert a disc into the disc compartment with the printed side facing you. »» Play starts automatically after a few seconds.
6 Use the dock Control play During play, follow the instructions below to control play. Buttons Functions Pause or resume play. Stop play. Skip to the previous or next track. Press and hold to rewind a track or search forward fast. Skip to the previous or next album when one or more albums exist. Select an available play mode.
Enjoy audio through the dock 1 2 3 Press DOCK or SOURCE to switch the source to . Eject the dock. 4 12 Turn the dock tray to select a connector that matches your iPod/iPhone/iPad. EN Connect your iPod/iPhone/iPad to the dock. »» Once the iPod/iPhone/iPad is recognized, the charging starts.
5 Play a track on your iPod/iPhone/iPad. 7 Listen to FM radio Tune to an FM radio station Buttons MENU/ / / Start, pause, or resume play. Access the playlist of iPod/iPhone. Navigate through the playlist of iPod/iPhone. Skip to the previous/next track. Press and hold to rewind a track or search forward fast. Charge your iPod/iPhone/iPad Once the iPod/iPhone/iPad is docked and recognized, the charging starts.
Program radio stations automatically Note •• You can program a maximum of 20 preset radio stations. Press and hold SCAN/CLOCK until the frequency starts to change. »» All available stations are programmed in the order of waveband reception strength. Display RDS information RDS (Radio Data System) is a service that allows FM stations to transfer additional information. If you tune to an RDS station, an RDS icon is displayed.
8 Listen to DAB radio stations Tip •• You can re-scan to update the list of stored stations (see "Use DAB menus" > "Re-scan for stations"). •• You can tune to a station manually (see "Use DAB menus" > "Tune to a station manually"). Note •• For optimal reception, fully extend the antenna and adjust its position. •• You can program a maximum of 20 DAB radio stations. •• Check with local retailer or go to www.WorldDAB.org for applicable DAB radio frequencies in your area.
Display DAB information Press DISPLAY repeatedly to cycle through the following information (if available). • Dynamic label segment (DLS) • Signal strength • Program type (PTY) • Ensemble name • Frequency • Signal error rate • Bitrate codec • DAB/DAB+ • Time • Date Use DAB menus 1 2 In DAB mode, press MENU to access the DAB menus. Press menus. / to toggle through the Re-scan for stations Full scan is used to perform a wide range search for DAB radio stations.
9 Adjust sound 10 Other features The following operations are applicable to all supported media. Use the alarm timer Select a preset sound effect This product can be used as an alarm clock. You can select the disc, iPod/iPhone/iPad library, FM radio station, DAB radio station, or .mp3 files stored on a USB storage device as alarm source. • Press SOUND repeatedly to select a preset sound effect. • , , , , and Adjust volume level • • On the remote control, press VOL +/repeatedly.
Deactivate/Re-activate the alarm timer Listen to an external device In standby mode, press SLEEP/TIMER. »» If TIMER disappears, the alarm timer is deactivated. You can also listen to an external audio device, for example, MP3 player, through this product. »» If TIMER is displayed, the alarm timer is activated. Stop an alarm When an alarm rings, press to stop it.
Charge your USB device You can charge your USB device, for example, smart phone, with this product. Note •• The output voltage through the USB socket is 5 V with output currency 0.5 A. •• WOOX Innovations does not guarantee the compatibility with all USB devices. Connect your USB device to this product with USB cable. 11 Use system menus Use the system menus to • check the version of current software of this product, • upgrade the software, and • reset the product to factory default status.
3 4 5 Click the link of "Installation instructions". Read and understand the instructions on software upgrade. Follow the instructions to complete the upgrade. 12 Product information Note •• Product information is subject to change without prior notice. Specifications General information AC power adaptor Operation power consumption Eco standby power consumption USB Direct Max.
Disc Laser type Disc diameter Support discs Audio DAC Total harmonic distortion Frequency response S/N Ratio Semiconductor 12 cm CD-DA, CD-R, CD-RW, MP3-CD 24 Bits, 44.1 kHz < 1.5% (1 kHz) 60 Hz - 16 kHz (44.1 kHz) > 55 dB Tuner Tuning range Tuning grid Sensitivity - Mono, 26dB S/N Ratio - Stereo, 46dB S/N Ratio Search selectivity Total harmonic distortion Signal-to-noise ratio Number of preset radio stations FM: 87.50 108.00 MHz; DAB: 174.928239.
Maintenance Clean the cabinet • Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives. Clean discs • When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out. • Do not use solvents such as benzene, thinner, commercially available cleaners, or antistatic spray intended for analogue records. Clean the disc lens • After prolonged use, dirt or dust may accumulate at the disc lens.
Problem Remote control does not work. Solution Before you press any function button, select the correct source with the remote control instead of the main unit. Reduce the distance between the remote control and the main unit. Insert the battery with its polarity (+/– signs) aligned as indicated. Replace the battery. Aim the remote control directly at the sensor on the front panel of the main unit. No disc is Insert a disc. detected. Make sure that you place the disc with its label facing upwards.
14 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Compliance This product complies with the radio interference requirements of the European Community. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ EC.
Trademark notice “Made for iPod,” “Made for iPhone,” and “Made for iPad” mean that an electronic accessory has been designed to connect specifically to iPod, iPhone, or iPad, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod, iPhone, or iPad may affect wireless performance.
26
Specifications are subject to change without notice 2013 © WOOX Innovations Limited. All rights reserved. This product was brought to the market by WOOX Innovations Limited or one of its affiliates, further referred to in this document as WOOX Innovations, and is the manufacturer of the product. WOOX Innovations is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. DCB2270_10_UM_V1.
