Register your product and get support at www.philips.
1 Important Know these safety symbols Hearing Safety 2 Your Micro System Introduction What's in the box Overview of the main unit Overview of the remote control 4 4 5 5 5 5 6 7 6 Listen to FM radio Tune to FM radio stations Store FM radio stations automatically Store FM radio stations manually Select a preset radio station Show RDS information Select stereo/mono broadcast Use FM menu 7 Other features 3 Get started Placement Prepare FM/DAB+ antenna Prepare the remote control Connect power Set clock Turn
1 Important Read these instructions. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the unit.
Danger 2 Your Micro System E n gl i s h Hearing Safety To avoid hearing damage, limit the time you use the headphones at high volume and set the volume to a safe level. The louder the volume, the shorter is the safe listening time. Be sure to observe the following guidelines when using your headphones. Listen at reasonable volumes for reasonable periods of time. Be careful not to adjust the volume continuously upwards as your hearing adapts.
Overview of the main unit a b MP3-LINK c SOURCE OK / MENU / VOLUME VOLUME d e f g h i j k p o n l FM ANT DC IN 12 V 3A m D O C K for a e Connect USB device. Headphone socket. Turn the unit on/off. Switch to standby mode. b c d SOURCE Select a source: CD, USB, DAB+, FM, MP3 Link, or Dock. 6 EN / Skip to the previous/next track. Search within a track/disc. Tune to radio stations. Adjust time. f OK / Start/pause play.
Open/close the disk tray. i VOLUME + / Adjust volume. j MENU / Access iPod/iPhone/iPad menu. Access FM/DAB+ menu. Stop play or erase a program. k Display panel Show play information. Overview of the remote control E n gl i s h h a b DAB c CD s FM PRESET/ALBUM l Disc tray r m DOCK for iPod/iPhone/iPad q n DC IN Connect power. o FM ANT Improve FM/DAB+ radio reception.
c CD Select CD source. p DOCK Select iPod/iPhone/iPad source. d q OK X % Switch between mono and stereo broadcast. / Skip to the previous/next track. Search within a track/disc. Tune to radio stations. Adjust time. e USB/MP3 LINK Select USB/MP3 link source. f RDS/DISPLAY For selected FM radio stations: display RDS information. Show time and play information. Show DAB+ information. g Start/pause play. h VOL +/ Adjust volume.
Caution Use of controls or adjustments or performance of To install the remote control battery: 1 2 Open the battery compartment. 3 Close the battery compartment. E n gl i s h 3 Get started Insert 2 AAA batteries with correct | } % procedures other than herein may result in hazardous radiation exposure or other unsafe operation. a Always follow the instructions in this chapter in sequence. b Placement ^ G mount the unit on a wall.
Connect the power adapter to: the DC IN socket on the main unit. the wall socket. Note The accuracy of the transmitted time depends on the DAB+ station that transmits the time signal. If no button is pressed in 90 seconds, the unit exits clock setting mode automatically. Turn on Press . » The unit switches to the last selected source. Note Set clock To select a source, press SOURCE repeatedly or the source selection buttons on the remote control. 1 Press to switch the unit to standby mode.
4 Play E n gl i s h Play from iPod/iPhone/iPad You can enjoy audio from iPod/iPhone/iPad through this unit. Play disc 1 2 3 4 Press Compatible iPod/iPhone/iPad to open the disc compartment. Insert a disc with the printed side facing up. Press to close the disc compartment. Press CD on the remote control to select the disc source. » [Reading] " # moment, then CD starts playing automatically. If not, press .
Install the rubber pad If necessary, install the supplied rubber pad to keep the iPad/iPad 2 stable before you place the iPad/iPad 2. Tip For certain iPod models, it may take up to a minute before the charging indication appears. Play options Pause/resume play During play, press to pause/resume play. Listen to the iPod/iPhone/iPad 1 Make sure that the iPod/iPhone/iPad is loaded correctly. 2 Press SOURCE repeatedly or DOCK on the remote control to select iPod/iPhone/ iPad source.
You can program a maximum of 20 tracks. 1 In CD/USB mode, press to stop playback, then press PROG to activate the programming mode. » [PROG] % 2 For MP3/WMA tracks, press select an album. 3 Press PROG 4 Repeat steps 2 to 3 to program more tracks. 5 Press to play the programmed tracks. » During play, [PROG displayed. / / to to select a track, then press % To erase the program, when playback is stopped, press .
Store DAB+ radio stations automatically Note New stations and services will be added in DAB+ broadcast from time to time. To make new DAB+ stations and services available, perform full scan regularly. In DAB+ mode, press SCAN. » The unit scans and stores all the available DAB+ radio stations and broadcasts the " % Select a preset DAB+ radio station In DAB+ mode, press channel number.
Note 6 Listen to FM radio E n gl i s h [System] [Factory Reset]: reset all the settings to factory default. [Software Upgrade]: update software if available. [SW version]: know the software version of the unit. Tune to FM radio stations If no button is pressed within 10 seconds, the menu Note exits. Position the antenna as far as possible from TV, VCR, or other radiation source. Make sure that you have connected and fully extended the supplied FM antenna.
Store FM radio stations manually Select stereo/mono broadcast Note 1 2 In tuner mode, tune to an FM radio station. 3 Press / number. 4 5 Press PROG Press PROG to activate programming mode. » [PROG] " # % repeatedly to select a channel Stereo broadcast is the default setting for tuner mode. For stations with weak signals: to improve the reception, change to monaural sound. In FM tuner mode, press OK to switch between mono and stereo broadcast.
5 Click the link of search results to access the Web page for registering your product. 6 Fill in necessary information about this product to complete the registration. E n gl i s h 7 Other features Adjust system settings Update software via USB port To upgrade the software of your micro system, follow these steps strictly: 1 1 2 Go to www.philips.com/welcome. 3 4 Check the latest software version. 5 6 In DAB+ mode, press MENU. 7 Select [Yes] to go to the upgrade stage.
Tip Set the alarm timer If CD/USB/dock/DAB+ radio is selected as alarm source and the audio cannot be played, FM tuner is activated automatically. This unit can be used as an alarm timer. You can select CD, FM tuner, iPod/iPhone/iPad, DAB, or USB as alarm source. Note Make sure that you have set the clock correctly. Set the sleep timer Note 1 In standby mode, press and hold TIMER until [SET TIMER] display. » [SELECT SOURCE] displayed.
Note Product information is subject to change without prior notice. Sensitivity - Mono, 26dB S/N Ratio - Stereo, 46dB S/N Ratio Search Selectivity Total Harmonic Distortion Signal to Noise Ratio Number of presets <22 dBf E n gl i s h 8 Product information <43 dBf \ Z <3% Z \ [ \ V*Z| General information AC power Rated Output Power Frequency Response Signal to Noise Ratio MP3 Link Input 2 X 10 W RMS 80 Hz - 16 kHz, ± 3 dB Z 0.
Directory nesting up to a maximum of 8 levels Number of albums/ folders: maximum 99 Number of tracks/titles: maximum 999 ID3 tag v2.0 or later File name in Unicode UTF8 (maximum > " Unsupported formats: Empty albums: an empty album is an album [J )[* $ is not be shown in the display. # % $ ) % [J @ % played.
Replace the battery. Aim the remote control directly at the sensor on the front of the unit. 10 Notice E n gl i s h No disc detected Insert a disc. Check if the disc is inserted upside down. Wait until the moisture condensation at the lens has cleared. Replace or clean the disc. XV % * device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment.
cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. DCB2070_10_UM_V2.
