Register your product and get support at www.philips.
1 Important 4 4 2 Your Micro Music System 5 5 5 6 7 Safety Introduction What's in the box Overview of the main unit Overview of the remote control 3 Before use Place the product Connect speakers Connect power Install/replace the remote control batteries 4 Get started Turn on Set clock Demonstrate features 5 Play Play a disc Play from a USB storage device Basic control Program audio tracks Adjust sound 9 9 9 9 9 10 10 11 11 12 12 12 12 12 13 6 Play from iPod/iPhone/iPad 13 13 13 14 14 15 7 Lis
1 Important Read and understand all instructions before you use this product. If damage is caused by failure to follow the instructions, the warranty does not apply. Safety Risk of electric shock! • Never expose the product and accessories to rain or water. Never place liquid containers, such as vases, near the product. If liquids are split on or into the product, disconnect it from the power outlet immediately. Contact Philips Consumer Care to have the product checked before use.
Be sure to observe the following guidelines when using your headphones. • Listen at reasonable volumes for reasonable periods of time. • Be careful not to adjust the volume as your hearing adapts. • Do not turn up the volume so high that you can't hear what's around you. • You should use caution or temporarily discontinue use in potentially hazardous situations. Note •• The type plate is located on the bottom of the product.
Overview of the main unit a o b n c d e f m g h l i j a Dock for iPod/iPhone/iPad b Disc compartment c • USB socket. d MP3-LINK • Connect an external audio device. e f • Headphone socket. • • Turn on the product. Switch to eco-power standby mode or normal standby mode. g IR sensor • Receive signals from the remote control. 6 EN k h SOURCE • Select a source. i / Skip to the previous or next track. Press and hold to search within a track/disc. • Tune to a radio station.
• • In normal standby mode, turn on or off feature demonstration. In DAB or FM mode, access the menu. Access the playlist of iPod/iPhone. l - PRESET/ALBUM+ • Skip to the previous or next album. • Select a preset radio station. • Navigate through iPod/iPhone/iPad menu. m Display panel • Display current status. n • Eject or close the disc tray. o VOLUME • Adjust the volume level or time.
c CD • Select CD source. d / Skip to the previous or next track. Press and hold to search within a track/disc. • Tune to a radio station. • • e MP3 LINK/USB • Select MP3 LINK or USB source. f RDS/DISPLAY • Synchronize the clock with an RDS radio station that transmits time signals. • Display the current status or media information. • Display available ID3 information of MP3 tracks. • When playing music from CD or USB storage device, display the clock. g • • Start, pause, or resume play.
• 3 Insert the red wires to "+", black wires to "-". English 3 Before use Release the socket flap. Place the product Connect power Caution •• Risk of product damage! Make sure that the power Place the speakers at an angle of approximately 45 degrees from the listening position. Note supply voltage corresponds to the voltage printed on the back or the underside of the product. •• Risk of electric shock! When you unplug the AC power cord, always pull the plug from the socket. Never pull the cord.
1 Open the battery compartment. 4 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. 2 Insert 2 AAA batteries with correct polarity (+/-) as indicated. Always follow the instructions in this chapter in sequence. Turn on Press . »» This product switches to the last selected source. 3 Switch modes Close the battery compartment.
Demonstrate features 1 1 2 3 4 5 6 In standby mode, press and hold PROG/CLOCK SET to activate clock setting. »» [CLOCK SET] (set clock) scrolls on the display, and then [CLOCK 24] (24-hour time format) is displayed with "24" blinking. 2 In normal standby mode, press . • [WELCOME TO PHILIPS] (welcome to Philips) scrolls on the display, and then feature names one by one. To exit the feature demonstration, press again.
5 Play 1 2 Connect the USB storage device into the (USB) socket. Press USB to select the USB source. »» Play starts automatically. If the play does not start automatically, Play a disc Caution 1 2 3 Press PRESET/ALBUM folder. / Press / Press to start the play. to select a to select a file. •• Risk of damage to the product! During play, never move the product. •• Never put any object other than a disc into the disc compartment. •• Never look at the laser beam inside the player.
•• The programmed tracks must be stored on the same disc or USB storage device. •• You can program a maximum of 20 tracks. Adjust sound During play, you can adjust the volume level and sound effect through following operations. Button Function VOL +/- Increase or decrease the volume. DBB DSC Mute or restore sound. Turn on or off the dynamic bass enhancement (DBB). • If DBB is activated, [DBB] is displayed.
2 Insert your iPod/iPhone/iPad onto the dock. Charge the iPod/iPhone/iPad When the product is connected to power, the docked iPod/iPhone/iPad starts charging automatically. Install the rubber bumper Note Tip •• For certain iPod models, it may take up to a minute before the charging indication appears. •• If your iPad 2 is not in a case, use the supplied rubber bumper to keep it stable. 1 Release the dock lid, and then place the rubber bumper onto the dock compartment.
• • To access the playlist of iPad/iPad 2, operate on the iPad/iPad 2 screen. To scroll through the playlist, press / . To confirm an option, press OK on the remote control. 7 Listen to radio English • Note •• For optimal reception, fully extend the antenna and Remove the iPod/iPhone/iPad 1 2 Pull the iPod/iPhone/iPad out of the dock. Flip down the lid to hide the dock. adjust its position, or connect an outdoor antenna. •• This product does not support MW (medium wave) radio reception.
Basic operations Use the menu Follow the instructions below for more functions. When you listen to radio, you can access the menu for control options. Tune to the next FM radio station with sufficient signal strength at the lower/higher frequency: Press and hold / to start the auto search. Tune to the FM radio station at a specific frequency: Press / repeatedly until the frequency digitals are displayed.
3 [RESET] (reset): Reset all radio settings to the factory default status. [SW VER] (software version): Display the version of the current firmware. [UPGRADE] (upgrade): Upgrade the firmware. Press MENU/ to exit the menu. 8 Other features English [SYSTEM] (system) Set sleep timer In working mode, press SLEEP/TIMER repeatedly to select a set period (in minutes). »» When sleep timer is activated, is displayed. • To deactivate sleep timer, press SLEEP/TIMER again until disappears.
5 6 Press / or VOL +/- to set minute, and then press SLEEP/TIMER again. »» [VOL] (volume) is displayed and begins to blink. Press / or VOL +/- to adjust volume, and then press SLEEP/TIMER to confirm. »» is displayed. To deactivate/activate the alarm timer, press SLEEP/TIMER repeatedly in normal standby mode. • Note •• When the alarm sounds, you can press VOL +/- to adjust volume. •• The alarm timer is not available in MP3 LINK mode.
Check the current firmware version English 9 Upgrade the firmware Follow the steps to check the current version of firmware on your product. Note •• Power supply must not be interrupted during the upgrade. •• The firmware upgrade can only be available through the mini-USB port on the back plate. •• When the firmware upgrade succeeds, all settings are restored to the factory default status. 1 2 3 4 5 6 Register your product 1 2 3 4 5 6 Go to www.philips.com/welcome.
10 Product information •• Product information is subject to change without prior notice. Speaker Impedance Speaker Driver Sensitivity Amplifier 2 x 10 W RMS 40 Hz-20 kHZ, ±3 dB > 77 dB 600 mV RMS 22 kohm Disc Audio DAC Total Harmonic Distortion Frequency Response S/N Ratio Semiconductor 12 cm/8 cm CD-DA, CD-R, CDRW, MP3-CD, WMACD 24 Bits / 44.1 kHz <0.8% (1 kHz) 4 Hz - 20 kHz (44.
Unsupported formats: • Empty albums: an album that does not contain MP3/WMA files • Unsupported file formats are skipped. For example, Word documents (.doc) or MP3 files with extension .dlf are ignored and not played. • AAC, WAV, PCM audio files • DRM protected WMA files (.wav, .m4a, .m4p, .
11 Troubleshooting Warning •• Never remove the casing of this device. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www.philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.
Solution Poor radio reception Increase the distance between the product and other electrical appliances. Fully extend the antenna. Connect an outdoor FM/DAB antenna instead. Set the clock correctly. Switch on the timer. Power has been interrupted or the AC power cord has been disconnected. Reset the clock/timer.
12 Notice Compliance Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste. Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Copyright This product complies with the radio interference requirements of the European Community.
This apparatus includes this label: Norge Typeskilt finnes på apparatens underside. Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten. For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.
Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N.V. All rights reserved. DCB2020_12_UM_V1.
