Register your product and get support at www.philips.com/welcome DC390 EN User manual DC390_05_UM_V4.0.
Contents 1 Important Safety Notice 4 4 6 8 Product information Specifications 18 18 9 Troubleshooting 19 2 Your Docking Entertainment System 8 Introduction What’s in the box Overview of the main unit Overview of the remote control 8 8 9 10 3 Get started 11 11 12 12 12 12 4 Play 13 13 14 14 5 Listen to radio 15 15 15 15 15 6 Other features 16 16 7 Adjust sound 17 17 17 17 17 Install batteries Prepare the remote control Connect power Set time and date Turn on Play from iPod/iPhone/iPad Inst
1 Important Safety g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. j Only use attachments/accessories specified by the manufacturer.
• • • Install all batteries correctly, + and as marked on the unit. Do not mix batteries (old and new or carbon and alkaline, etc.). Remove batteries when the unit is not used for a long time. o Apparatus shall not be exposed to dripping or splashing. p Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). q Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
• • • Be careful not to adjust the volume as your hearing adapts. Do not turn up the volume so high that you can’t hear what’s around you. You should use caution or temporarily discontinue use in potentially hazardous situations. Do not use headphones while operating a motorized vehicle, cycling, skateboarding, etc.; it may create a traffic hazard and is illegal in many areas. Notice This product complies with the radio interference requirements of the European Community.
Class II equipment symbol: CLASS II apparatus with double insulation, and no protective earth provided. Note •• The type plate is located at the bottom of the apparatus. EN DC390_05_UM_V4.0.
2 Your Docking Entertainment System Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can enjoy audio from iPod, iPhone, iPad, radio, or other audio devices. The radio, iPod, iPhone, or iPad can be set as the alarm timer. You can set two alarm timers to go off at different time.
Overview of the main unit p o n m a b c d DATE VOL SLEEP SOURCE SET TIME PROG e VOL ALARM 1 R E PE AT A L A R M BRIGHTNESS CONTROL ALARM 2 f l k j i h g a • /DATE View the clock time and date. b SLEEP • Set the sleep timer. c d e • • • • • • • / Search within an audio file. Tune to a radio station. /SET TIME/PROG Set the clock and date. Program radio stations. Turn on the unit or switch to standby mode. Deactivate the sleep timer. Stop alarm.
j OK/ • Start or pause iPod/iPhone/iPad play. • Confirm selection. • Select FM stereo or FM mono. k • • • / Skip to the previous/next audio file. Select a preset radio station. Adjust time. l VOL +/• Adjust volume. m Dock1 • Load an iPod/iPhone. n Dock2 • Load an iPod/iPhone/iPad. o FM antenna • Improve FM reception. p MP3-LINK • Jack for an external audio device.
• d • • Adjust time. / Search within an audio file. Tune to a radio station. e OK/ • Start or pause iPod/iPhone/iPad play. • Confirm selection. • Select FM stereo or FM mono. f MP3 LINK • Select external audio device source. g MENU • Select the iPod/iPhone menu. h SLEEP • Set the sleep timer. i BRIGHTNESS/REP ALM • Adjust the display brightness. • Repeat the alarm. j DBB • Turn on or off dynamic bass enhancement. k DSC • Select a preset sound setting. l ALM 1/ALM 2 • Set the alarm timer.
1 2 3 Open the battery compartment. Insert 2 x R6/UM-3/AA size batteries with correct polarity (+/-) as indicated. Note •• The type plate is located on the bottom of the main unit. Close the battery compartment. Caution •• Remove battery if it is exhausted or will not be used for a long time. •• Batteries contain chemical substances, so they should be disposed of properly. •• Perchlorate Material-special handling may apply. See www.dtsc.ca.gov/hazardouswaste/ perchlorate.
Switch to standby 1 Press POWER again to switch the unit to standby mode. »» The time and date (if set) appear on the display panel. 4 Play Play from iPod/iPhone/iPad You can enjoy audio from iPod/iPhone/iPad through this unit. Compatible iPod/iPhone/iPad Apple iPod and iPhone models with a 30-pin dock connector.
Charge the iPod/iPhone/iPad When the unit is connected to power, the docked iPod/iPhone/iPad begins to charge. • • • • • • To pause/resume play, press OK/ . To skip to a track, press / . To search during play, press and hold / , then release to resume normal play. To go back to the previous iPod/ iPhone menu, press MENU. To scroll through the menu, press / . To confirm a selection, press OK/ . »» If no key is pressed for more than 10 seconds, OK/ acts back as the play/pause key.
5 Listen to radio Note •• Only FM radio reception is available on this unit. Program radio stations automatically You can program a maximum of 20 preset radio stations. 1 Tune to a radio station In the tuner mode, press and hold SET TIME/PROG for more than 2 seconds to activate automatic program mode. »» [AUTO] (auto) is displayed. »» The unit automatically stores radio stations with sufficient signal strength. »» The first programmed radio station is broadcast automatically.
6 Other features Set the alarm timer You can set two alarms which go off at different time. 1 2 3 4 5 6 7 8 9 Make sure that you have set the clock correctly. (See “Get started - Set time and date”.) Press and hold ALM 1 or ALM 2 for two seconds. »» [AL 1] or [AL 2] begin to blink. Press SOURCE on the top panel to select an alarm sound source: DOCK1, DOCK2, FM tuner, or buzzer. »» If the timer is deactivated, [ AL1] or [ AL2] is displayed. Repeat alarm 1 Tip •• You can press repeat alarm.
7 Adjust sound Adjust volume level 1 During play, press VOL +/- to increase/ decrease the volume level. Mute sound 1 During play, press MUTE to mute/unmute sound. Select a preset sound effect 1 During play, press DSC repeatedly to select: • [ROCK] (rock) • [JAZZ] (jazz) • [POP] (pop) • [CLASSIC] (classic) • [FLAT] (flat) Enhance bass 1 During play, press DBB to turn on or off dynamic bass enhancement. »» If DBB is activated, [DBB] is displayed. EN DC390_05_UM_V4.0.
8 Product information Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power Frequency Response Signal to Noise Ratio Aux Input (MP3 link) General information AC power Operation Power Consumption Standby Power Consumption (clock display) Dimensions - Main Unit (W x H x D) Weight - With Packaging - Main Unit 100-240 V, 50/60 Hz 17 W <1 W 263 x114 x 165 mm 2.4 kg 1.
9 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
© 2012 Koninklijke Philips Electronics N.V. All rights reserved. DC390_05_UM_V4.0 DC390_05_UM_V4.0.
