Register your product and get support at www.philips.
Important safety instructions Warning • The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible. • Refer to safety information before using the product. • This product complies with European R&TTE directive 1999/5/EC. • Use only the power supply listed in the user instructions. • Use only the batteries listed in the user instructions.
1 Overview In call Phonebook / redial list Change the sound profile. Adjust the volume. Recall (network dependent). End calls. Enter a pause (press and hold). Turn the speaker on/off. Mute/unmute the microphone. Standby Access the main menu. Access the redial list. Phonebook Call log Make and receive calls. Switch the handset on or off (press and hold). Make intercom call (press and hold). Lock/unlock the keypad (press and hold). Make and receive calls through the speaker.
2 Connect
3 Get started Insert batteries Charge your phone Configure your phone 1 When using your phone for the first time, you see a welcome message (country dependent). 2 Register your handset if prompted (see the section on “Register additional handsets”). 3 Set the date and time. • If the time is in 12-hour format, press / to select [am] or [pm] (country dependent).
4 Register additional handsets You can register additional handsets to the base station. Auto registration Place the unregistered handset on the base station. »» The handset detects the base station and registers automatically. »» Registration is complete in less than 2 minutes. The base automatically assigns a handset number to the handset. Manual registration 1 Press [Menu]. > [Register]. 2 Press / to select 3 Press and hold on the base station for 10 seconds. 4 Enter the system PIN/passcode (0000).
Technical data Battery Philips: 2 x AAA NiMH 1.2 V Rechargeable 650 mAh batteries Use only the supplied batteries. Adapter (Base and charger:) Tenpao: S003GB0600050 Input: 100-240 V~, 50/60 Hz 150 mA Output: 6 Vdc 500 mA Talk time: 18 hours Standby time: 250 hours Note • You can install a DSL (digital subscriber line) filter to prevent noise and caller ID problems caused by the DSL interference. • You can find the Declaration of Conformity on www.p4c.philips.com.
Frequently asked questions No signal bar is displayed on the screen. • The handset is out of range. Move it closer to the base station. • If the handset displays [Register your Handset], register your handset. (See the section on “Register additional handsets”). If I fail to pair (register) the additional handsets to the base station, what do I do? > > • Your base memory is full. Access [Unregister] to unregister the unused handsets and try again.
www.philips.com/support To access the user instructions online, use the reference model number written on the product label at the bottom of the charger.
This symbol on a product means that the product is covered by European Directive 2012/19/EU. 2015 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. 0168 UMS_D6350 12_EN_v3.
