Register your product and get support at www.philips.
Important safety instructions Warning • The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible. • Refer to safety information before using the product. • This product complies with European R&TTE directive 1999/5/EC • Use only the power supply listed in the user instructions. • Use only the batteries listed in the user instructions.
1 Overview In call Enter the option menu Adjust the volume End calls Turn the speaker on/off Mute/unmute the microphone Enter a pause Standby Access the main menu Phonebook Call log Make and receive calls Make intercom call Lock/unlock the keypad.
2 Connect
3 Get started Insert batteries Charge your phone Configure your phone 1 Set the country and language if prompted. 2 Set the date and time. • If the time is in 12-hour format, press [am] or [pm] (country dependent).
4 Register additional handsets You can register additional handsets to the base station. Auto registration Place the unregistered handset on the base station. »» The handset detects the base station and registers automatically. »» Registration is complete in less than 2 minutes. The base automatically assigns a handset number to the handset. Manual registration > [Register], then press 1 Select [Menu] > [OK] to confirm. 2 Press and hold on the base station for 5 seconds. 3 Enter the system PIN/passcode.
Technical data Battery • Philips: 2 x AAA NiMH 1.2 V Rechargeable 550 mAh batteries Use only the supplied batteries. Adapter Philips: MN-A102-U130 S003IB0600040 Input 100-240 V~ 100-240 V~ 50/60 Hz 200 mA 50/60 Hz 150 mA Output 6 V 400 mA 6 V 400 mA Talk time: 18 hours Standby time: 250 hours Note • You can install a DSL (digital subscriber line) filter to prevent noise and caller ID problems caused by the DSL interference. • You can find the Declaration of Conformity on www.p4c.philips.com.
Frequently asked questions No signal bar is displayed on the screen. • The handset is out of range. Move it closer to the base station. • If the handset displays [Register your Handset], put the handset on the base until the signal bar appears. If I fail to pair (register) the additional handsets to the base station, what do I do? Your base memory is full. Access > > [Unregister] to unregister the unused handsets and try again.
www.philips.com/support For information, refer to the extended user documentation online.
0168 Reproduction in whole or in part is prohibited without the written consent of the copyright owner. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners. All rights reserved. © 2013 Koninklijke Philips Electronics N.V. QSG_D6050 12_EN_V1.
