User manual

13
English
EN
9 Troubleshooting
Warning
•
Risk of electric shock. Never remove the casing of the
product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following sections before you request service.
If you still have a problem, register your product
and get support at www.philips.com/welcome.
Sound
No sound from SoundHub.
• Make sure that the SoundHub is not
muted. Press
to select MUTE OFF on
the display panel.
• Connect the audio cable from your
SoundHub to your TV or other devices.
• Reset your SoundHub to its factory
settings, and then switch it off and switch
on again.
• On your remote control, press AUX,
COAXIAL/OPTICAL, or MUSIC iLINK
repeatedly to select the correct audio
input on the display panel (see 'Listen to a
connected device' on page 9).
Distorted sound or echo.
• If you play audio from the TV through the
SoundHub, make sure that the TV is muted.
Audio and video are not synchronized.
• 1) Press AUDIO SYNC. 2) Within two
seconds, press the Navigation buttons (
/ ) to change the delay shown on the
display panel. 3) Press AUDIO SYNC again
to exit.
10 Index
A
amplier 12
audio
auto volume 10
night mode 10
sound mode 9
specications 12
surround sound mode 10
audio source
remote control 9
C
care
environment 4
product 4
compliance 2
connect
audio (analog cable) 9
audio (coaxial cable - digital) 8
audio (optical cable - digital) 8
audio from TV and other devices 8
speakers 6
connectors
back connectors - main unit 7
back connectors - subwoofer 8
side connector 7
D
disable
auto volume 10
night mode 10
display panel 5
E
enable
auto volume 10
night mode 10