Operation Manual

13
English
EN
Note
• If the surround speakers are undocked from the main
unit, it is xed to surround mode only.
Equalizer
Change the high frequency (treble) and low
frequency (bass) settings of this product.
1 Press TREBLE +/- or BASS +/- to change
the frequency.
» If the treble or bass is set to the
maximum or minimum, the white LED
on the main unit lights up for two
seconds.
2 To reset the bass and treble to the default
setting, press RESET
.
Auto volume
Turn the auto volume on to keep the volume
constant when you switch to a different source.
It also compresses the sound dynamics,
increasing the volume for quiet scenes and
decreasing the volume for loud scenes.
1 Press AUTO VOL. ON/OFF to turn auto
volume on or off.
Synchronize picture and sound
If the audio and video are not synchronized,
delay the audio to match the video.
1 Press AUDIO SYNC +/- to synchronize
the audio with the video.
• AUDIO SYNC + increases the sound
delay, and AUDIO SYNC - decreases
the sound delay.
» If the value of sound delay is set to
the maximum or minimum, the white
LED on the main unit lights up for two
seconds.
Night mode
For quiet listening, decrease the volume of loud
sounds when audio is played. Night mode is
only available for Dolby Digital soundtracks.
1 In AUDIO IN mode, press and hold AUTO
VOL. ON for ve seconds to turn night
mode on or off.
» If night mode is turned on, the white
LED and the standby LED blink twice.
» If night mode is turned off, the white
LED and the standby LED blink three
times.
Note
• If auto volume is set to turned on, you cannot enable
the night mode.
MP3 player
Connect your MP3 player to play your audio
les or music.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
1 Using the 3.5mm stereo audio cable,
connect the MP3 player to the AUDIO IN
connector on the left base speaker.
2 Press AUDIO IN.
3 Press the buttons on the MP3 player to
select and play audio les or music.
• On the MP3 player, it is recommended
to set the volume in the range of 80%
maximum volume.