Quick start guide
Register your product and get support at
Registre su producto y obtenga asistencia en
Cadastre seu produto e obtenha suporte em
CMD310
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
CMD310_55_QSG_V1.0
EN Quick start guide
ES-AR Guía de inicio rápida
PT-BR Guia de início rápido
What's in the box
a Main unit and front panel (with a sleeve) b Trim plate
c ISO standard connector d Rubber cushion
e 1 x Screw f 2 x Disassembly tools
g User manual h Quick start guide
Connect wires
1
Check the car’s wiring carefully, and then connect them to the supplied ISO wires.
Connector Connect to
1 Yellow wire The +12V car battery which is live at all times
2 Blue/White wire The electric antenna control lead or power supply lead of the antenna booster. If
there is no electric antenna or antenna booster, or it is manually operated telescopic
antenna, it is unnecessary to connect this lead.
3 Black wire A metal surface of the car. Connect the black ground (earth) lead before connecting
the yellow and red power supply leads.
4 Red wire The +12V power terminal which is live in the accessory (ACC) position of the ignition
switch. If there is no accessory position, connect to the +12V car battery terminal that
is always live. Make sure that the black ground (earth) lead is connected to a metal
5 Green and
green/black wires
Left speaker (rear)
6 White and white/
black wires
Left speaker (front)
7 Gray and gray/
black wires
Right speaker (front)
8 Purple and
purple/black
wires
Right speaker (rear)
2 Connect the other end of the supplied standard connector to the car audio system.
Connector Connect to
1 ANTENNA Antenna for radio
2 External Mic An external microphone for phone call
3 SUBWOOFER (Socket) Subwoofer
4 REAR LINE OUT L (Socket) Rear left speaker
5 REAR LINE OUT R (Socket) Rear right speaker
6 OE REMOTE (Brown) OE remote
7 FRONT LINE OUT L Front left speaker
8 FRONT LINE OUT R Front right speaker
Mount into the dashboard
If the car does not have an on-board drive or navigation computer, disconnect the negative terminal of the car
battery.
If you disconnect the car battery in a car that has an on-board drive or navigation computer, the
computer may lose its memory.
If the car battery is not disconnected, to avoid short-circuit, make sure that the bare wires do not
touch each other.
1 Make sure that car dashboard opening is within these measurements:
2
Note
3 Place the supplied r ubber cushion over the end of the mounting bolt.
4 Slide the system into the dashboard until you hear a “click”.
5 Attach the trim plate.
6 Reconnect the negative terminal of the car battery.
Turn on
Press .
» [WELCOME] scrolls.
To turn off the system, press and hold
until [GOODBYE] is displayed.
Set the clock
1
Press and hold to access the system menu.
2 Press repeatedly until [CLOCK] and the current time is displayed.
» If the clock is not set before, [00:00] is displayed.
3 Rotate to set the hour.
4 Press
5 Rotate to set the minute.
6 Press
dca
Quick start guide
e
f
g
h
a
b
c
d
e
f
g
h
SUB-W
REAR LINE OUT
L
R
183 mm
53m
m
5m
m
183 mm
53.5 mm
RESET
RESET
MP3-LINK
CLICK
Á Quick start guide