User manual

8 EN
Mount into the dashboard
Note
•
If your car has no an on-board drive or navigation
computer, disconnect the negative terminal of the car
battery.
• If your car has an on-board drive or navigation
computer, the computer may lose its memory when
you disconnect the car battery.
• If the car battery is not disconnected, to avoid short-
circuit, make sure that bare wires do not touch each
other.
1 Make sure that the car dashboard opening
is within these measurements.
2 Install the sleeve into the dashboard and
bendthetabsoutwardtoxthesleeve.
Note
•
Ifthesystemisnotxedbysleevebutbythesupplied
screws, skip this step.
183 mm
53mm
5mm
183 mm
53.5 mm
3 Place the supplied rubber cushion over the
end of the mounting bolt.
4 Slide the system into the dashboard until
you hear a "click".
5 Attach the trim plate.
6 Reconnect the negative terminal of the car
battery.