Register your product and get support at www.philips.
1 Important Safety Notice 6 Play with Bluetooth device 4 4 4 2 Your in-car entertainment system 6 Introduction 6 What’s in the box 6 Install the car audio 7 Overview of the main unit 10 Overview of controls on host car audio 11 3 Get started Turn on Adjust volume Mute Set date and time 4 Listen to radio Tune to a radio station Store radio stations in memory Tune to a preset station 5 Play Load discs Connect USB device Insert USB or SD/MMC card Play/Pause Skip/search Search within a title/folder Repea
1 Important • Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). Safety • • • • • • • • • • • • • • • 4 Read and understand all instructions before you use the apparatus. If damage is caused by failure to follow instructions, the warranty does not apply. Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.
Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When you see the crossed-out wheel bin symbol attached to a product, it means the product is covered by the European Directive 2002/96/EC: Never dispose of your product with other household waste. Please inform yourself about the local rules on the separate collection of electrical and electronic products.
2 Your in-car entertainment system What’s in the box Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer. Caution • This unit is designed for negative ground (earth) 12 V DC operation only. Note English Install the car audio • As different cars have different requirements, you might need to connect CID3695 differently from the user manual’s instructions.
Check the car’s wirings carefully, then connect the in-car system as follows.
English Caution • Keep the connection of the car battery if there is an on-board drive or navigation computer. Otherwise, the computer may lose its memory. • To avoid short circuit, ensure the bare wires do not touch each other and disconnect the negative terminal of the car battery. 1 Fix the supplied rubber cushion with the mounting bolt. 2 3 Slide the unit into the dashboard. 4 Reconnect the negative terminal of the car battery. Fix the main unit with four screws.
Overview of the main unit a b c a • Built-in microphone. • SD/SDHC card slot. b c MAP • GPS map card slot.
English Overview of controls on host car audio a q b p RADIO c CD d e f AUX o FAV BAND 2 1 3 4 TONE 6 AS n m CONFIG BACK g 5 l k INFO h j i a • • Turn on or off the in-car system. Adjust volume. • • Search forward. Skip to the previous track. j INFO • Adjust the screen brightness. • Turn off the display screen. k b c RADIO BAND • Switch to the radio source. • Select radio band. d CD • Switch to the disc source. e TONE • Access the sound settings.
3 Get started Mute 1 During play, tap to turn off sound. • To restore sound, tap again. Caution • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Turn on Set date and time Caution 1 Tap 2 3 Tap [Settings]. to display the main menu. • Risk of road accidents! Never watch video or adjust settings while you drive.
English 4 Listen to radio Tune to a radio station 3 Tap or to set year, month and day. 1 2 Tap 3 Tap on FM or AM to select band: • FM band options: FM1, FM2, FM3 • AM band options: AM1, AM2 4 Briefly tap or to tune to a radio station by step. • Tap or for more than 1 second to tune to a radio station automatically. Set clock mode 1 Tap [Clock mode]. 2 Tap on [12Hr] or [24Hr] to select clock mode. Set time 1 2 Tap [Time]. Tap on the displayed time. » A submenu is displayed.
4 Tap one of the channels 01 to 06 to save the selected band. 5 Play Make sure that the disc or device contains playable music or video. Note • For CDs recorded in multiple sessions, only the first session is played. Store stations automatically You can search for a station with intro search, which broadcasts a 10-second preview of each detected radio station. 1 2 3 characters track name (ID3) or album name properly. • It cannot play some WMA is protected by Digital Rights Management (DRM).
2 Insert the USB storage device to the USB socket. » Play starts automatically. Press the card until you hear a click sound. » The card is now disengaged. 3 Remove the card. English Connect USB device Play/Pause 1 Insert a disc, USB or SD/SDHC card. » Play starts automatically. Remove the USB device 1 2 » For DVD movie, if a menu appears, tap a menu option to play. Switch to another (non-USB) source. Remove the USB storage device. 2 Insert USB or SD/MMC card 1 2 To pause, tap .
Search within a title/folder For audio files: 1 2 Tap . » The search screen is displayed. Tap the numbers to input track/file number, then tap . • To clear the previous input, tap • To clear all input, tap . . 2 Tap 3 Tap to select: • [Repeat chapter]: play the current chapter repeatedly. • [Repeat title]: play all chapters in the title repeatedly. • [Repeat off]: cancel repeat play. For video files: 1 Tap anywhere except for the upper left corner to display menu on the screen, if necessary.
Select audio language You can repeat a specific section of video file (repeat A-B). For video discs that contain two or more audio channels. 1 During play, tap anywhere except for the upper left corner to display menu on the screen, if necessary. 1 During play, tap anywhere except for the upper left corner to display menu on the screen, if necessary. 2 Tap to display the 2nd menu, if necessary. 2 3 Tap Tap repeatedly to select: • [Repeat A-]: the start of the section to repeat.
6 Play with Bluetooth device 2 Tap repeatedly to rotate the picture. Zoom You can zoom in pictures for a close view. 1 2 During picture viewing, tap anywhere except for the upper left corner to display menu on the screen, if necessary. Tap repeatedly to zoom in the picture. With this in-car system, you can: • make or answer phone calls through a Bluetooth-enabled phone. • listen to music from a Bluetooth-enabled device.
To disconnect one device, tap (red). » (green) is displayed. Tip Answer a call By default, the in-car system answers all incoming calls automatically. 1 If there is incoming call, [Incoming call...] flashes on the screen. Speak into the microphone. 2 When conversation ends, tap to terminate the call. • When the Bluetooth device is out of the operational range, the Bluetooth connection will disconnect. • If you want to reconnect the device to the unit, place it within the operational range.
» The Bluetooth menu is displayed. 4 • 1 2 Start to play music stored in the device. If the device supports Audio Video Remote Control Profile (AVRCP) profile, you can use controls on the in-car system to play music stored in the device. Tap Tap 2 Note • You may need to upgrade the map (sold separately) before using it (see “Upgrade the map” section). . to start play. Adjust Bluetooth settings 1 7 Use map In Bluetooth menu, tap . » The option menu is displayed.
» The speakers and subwoofer setup menu is displayed. English 8 Adjust sound settings Select preset equalizer 1 2 3 4 Tap anywhere except for the upper left corner to display menu on the screen, if necessary. 4 Tap . » The equalizer setup menu is displayed. Tap or to adjust subwoofer volume. • [Sub] subwoofer volume: 0 to 24. 5 Tap F, R, L, or R to adjust fader/balance value. • [Fade] fader range: +24 to -24. (F = front speaker, R = rear speaker) • [Balance] balance range: -24 to +24.
9 Adjust system settings [Radio region] Display system setup menu 1 Tap to display the main menu. [Radio range] [Blackout] 2 Tap [Settings]. » The settings menu is displayed. Tip • When the setup is complete, tap to return to the main menu. Adjust general settings 1 Tap [General]. [Dimmer Mode] 2 3 Tap [Key color] General settings 22 or to highlight an option. Tap on the option to display and change the settings. EN Options Description [Beep] [USA], [S.
[WallPaper] [Blue] [Black] [Red] [F1] [Calibration] 4 Tap Turn off the beep sound. Change background color to blue. Change background color to black. Change background color to red. Select F1 picture as wall paper. Calibrate the touch screen. [DRC] [On] [Off] 3 Tap Makes loud sound level softer and soft sound level louder so that you can watch the DVD movies at a low volume, without disturbing others The DRC function is off. to exit. Adjust video settings 1 Tap [Video].
[PAL] For users in China, India, Singapore, the western European countries (except France), and Australia, select this option. [Secam] For users in France, Russia and other countries, select this option. [Rear [Normal] When you drive in camera] reverse, the rear view is displayed normally. [Mirror] When you drive in reverse, the rear view is displayed in mirror. [Parking] [On] Disable video view during driving. [Off] Enable video view during driving. [DivX View code for DivX registration registration.
[DVD subtitle] [Disc menu] 3 Tap [English] Select DVD audio language. Options available depend on DVD disc. [ࡩᇓ໗] [ْᇓ໗] [English] Select DVD subtitle language. Options available depend on DVD disc. [ࡩᇓ໗] [ْᇓ໗] [Off] Turn off subtitle language display. [English] Select DVD menu language. Options available depend on DVD disc. [ࡩᇓ໗] [ْᇓ໗] to exit. Adjust volume settings You can set different volume for different modes. 1 Tap [Volume]. » The volume setting menu is displayed. 2 Tap on a source.
[Load factory] 3 Tap 26 EN Restore default settings. to exit.
11 Play from rear displays 1 In the main menu, tap [Car setting]. » The car setting menu is displayed. 2 Select an item, and then change the settings. When you connect rear displays to the in-car system, you can choose either to show the same image as the main unit or to show the selected source on Rear displays. 1 Make sure that your in-car system is connected to rear displays successfully. 2 Play a disc, or play from SDHC, USB, or AV-IN1 on the main unit.
USB USB AV IN 1 AV IN 1 USB 4 To exit, tap [Front Zone].
Replace fuse Listen to other devices If the system does not power on, the fuse may be damaged and need replacement. 1 Make sure that the external device is connected to the in-car system (see “Connect wires” section). 2 Tap 3 4 Tap [AV-IN1]. to display the main menu. 1 2 3 Take out the unit from dashboard. 4 Replace the fuse. Check the electric connection. Buy a fuse that matches the voltage of the damaged fuse (15A) Play the connected device (see the instructions manual of the device).
13 Product information • Product information is subject to change without prior notice.
English Supported MP3 disc format: • ISO9660, Joliet • Maximum title number: 512 (depending on file name length) • Maximum album number: 255 • Supported sampling frequencies: 32 kHz, 44.1kHz, 48 kHz • Supported Bit-rates: 32-320 Kbps and variable bit rate Supported video formats: • DVD • Divx Home theater • Xvid Note To ensure a better playback, it is recommended that: • the image size is not larger than 640 X 480 pixels. • the frame rate is 20 fps. • the data rate is not higher than 500 kbps.
14 Troubleshooting Warning • Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power • Car engine has not been started.
The system is not in the pairing mode. The system is already connected with another Bluetooth-enabled device. Disconnect that device or all other connected devices and then try again. English • • The paired mobile phone connects and disconnects constantly. • The Bluetooth reception is poor. Move the mobile phone closer to the system or remove any obstacle between the mobile phone and the system. • Some mobile phones may connect and disconnect constantly when you make or end calls.
15 Glossary B Bite rate The max data transfer through the USB port. Bluetooth Bluetooth® is a short-rang wireless protocol that is meant to allow mobile devices to share information and applications without the worry of cables or interface incompatibilities. The name refers to a Viking King who unified Denmark. Operate at 2.4GHz. For more information, see www.bluetooth.com. M MMC MultimediaCard. A type of memory card with a flash memory. MP3 A file format with a sound data compression system.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. CID3695_00_UM_V1.
