Register your product and get support at www.philips.
1 a j a b c d e i h f g b
c Amarelo Verde Azul Amarelo Controle de toque Tela traseira Amarelo CÂMERA Branco Amarelo Vermelho Amarelo Tela traseira Headphone wireless Vermelho Branco Amplificador Marrom Vermelho Branco Branco Sistema AV Vermelho Amarelo Preto Vermelho Preto
a m m 3.
itninggininCChhininaa PPrrinint 3 c
4 a b
English Install the car audio Connector 1 Brown wire Telephone mute 2 Red wire 3 Orange wire Illumination switch 4 Black wire 5 Yellow wire The +12V car battery which is live at all times. 6 Blue wire 7 Green and Left speaker (Rear) green/black wires 8 White and white/black wires Left speaker (Front) 9 Gray and gray/black wires Right speaker (Front) These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment.
Mount in the dashboard 2 Note To adjust screen brightness/contrast, press / on the remote control, then press , , or . To turn off the unit, press for 3 seconds Check wire connection before you mount the unit into a car. If preset radio stations are lost when the ignition key is turned OFF and then back ON, reconnect the red leads crosswise to the yellow ones. 1 If the car does not have an on-board drive or navigation computer, disconnect the negative terminal of the car battery.
Use map Note You may need to upgrade the map (sold separately) before using it (see “Upgrade the map” section) 3 Touch or to set year, month and day. Set clock mode 1 1 2 Touch [Clock mode]. Touch the upper left corner to display home menu. Touch [Navigation]. » The navigation menu is displayed in a few seconds. 3 Refer to the map manual to operate the navigation tool. Tip You can press NAVI to enter/exit the 2 Set time 1 2 navigation system.
Play disc Play USB device 3 You can play video, audio or images stored on the following discs: DVD video, DVD-R, DVD-RW VCD Audio CD, CD-R, CD-RW Note Note Ensure that the device contains playable content. 1 2 Ensure that the disc contains playable content. 1 4 Insert the disc into the disc slot with label side facing up. Open the USB door. a Insert the small end of the supplied USB cable to the USB socket, then connect the other end of the USB cable to your USB device.
3 Touch [Bluetooth]. Tip » The Bluetooth menu is displayed. You can select to receive calls manually by set [Auto answer] to [Off] status. 4 Touch or then touch 5 Touch or to search for phone number from the following list: Or touch to dial. to select the paired phone, . to dial number directly, then touch Receive call By default, all incoming calls are received automatically. 1 If there is incoming call, [Incoming call...] ÁDVKHV RQ WKH VFUHHQ 6SHDN LQWR WKH Bluetooth microphone.
© 2010 Koninklijke Philips Electronics N.V. All rights reserved. CID2680_00_QSG_V1.
