Register your product and get support at www.philips.
1 Important 4 Safety Notice 4 4 2 Your in-car entertainment system Introduction What’s in the box Overview of the main unit 3 Get started Install the car audio Turn on Set date and time 4 Use navigation system Insert map card Use map Upgrade the map 5 Listen to radio Tune to a radio station Store radio stations in memory Tune to a preset station 6 6 6 7 8 8 11 11 12 12 12 13 13 13 14 14 7 Play with Bluetooth device 19 Pair Bluetooth devices Make a call Receive call Listen to music from Bluetoo
1 Important Safety • • • • • • • • • • • • • • • 4 Read and understand all instructions before you use the apparatus. If damage is caused by failure to follow instructions, the warranty does not apply. Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. This unit is designed for negative ground (earth) 12 V DC operation only. To reduce the risk of traffic accident, do no watch video during driving.
This product complies with the radio interference requirements of the European Community. Recycling a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. 2010 © Koninklijke Philips Electronics N.V. All rights reserved.
2 Your in-car entertainment system Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
a English Overview of the main unit j b c d e f g h i a Built-in microphone b • Eject disc. c SRC • Select source. • Turn the screen on or off. d VOL/ /MUTE • Adjust volume. • Turn the unit on or off. • Turn mute on or off. e RESET • Reset when it hangs up.
3 Get started Caution • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Note on the power supply lead (yellow) • When you connect other devices to this system, ensure that the rating of the car circuit is higher than the total fuse value of all the connected devices.
Mount the brackets onto the unit with the screws. 7 Slide the unit into the dashboard until a click sound is heard. 5 Take off the two screws on the top side of the unit. 8 Fix the unit onto the dashboard with screws. 9 Mount on the trim plate. 6 English 4 Mount on the supplied bolt and rubber cushion, if necessary. 10 Reconnect the negative terminal of the car battery.
Connect wires Caution • Ensure that all loose leads are insulated with electrical tape. Pink Yellow Green Yellow Blue Orange/ white Yellow Connect it to the metal body or chassis of the car b c GPS antenna White/ brown Yellow Yellow Optional accessory Amplifier Red Connect to the positive (+) terminal of reverse driving lamp White Remark: c Connect the AV IN cable to the AV IN socket on front panel.
Turn on Caution English Set date and time 1 Tap . » The main menu is displayed. • Risk of road accidents! Never watch video or adjust settings while you drive. 1 Press to turn on the unit. » The available OSD (On-Screen Display) languages are displayed. 2 3 2 Tap a language. » The OSD language is changed to the selected language immediately. • To turn off the unit, press Tap [Time]. » The date/time setup menu is displayed. for 3 seconds. Turn the screen on/off 1 Tap [Settings].
2 Tap [12H] or[24H] to select clock mode. Set time 1 2 Tap [Time]. 4 Use navigation system Tap the displayed time. » A submenu is displayed. Insert map card Note • Navigation map card is not included in the packaging of the car entertainment system. 3 Tap or to set hour and minute. 1 2 Open the card door. 3 Close the card door. Insert the map card into the map card slot. Tip • When date/time is set, tap to return to main menu.
Refer to the user manual of the navigation map to operate the navigation tool. Upgrade the map 1 Exit navigation system. 2 Open the card cover. press on the map 5 Listen to radio English 3 Tune to a radio station 1 Tap to display home menu. 2 Tap [Radio]. » Band and frequency information is displayed. card until you hear a click sound. 3 Pull out the map card and bring it to the authorized service center for upgrade. 4 Insert the upgraded map card back into the card slot. 5 Turn on the car audio.
4 Tap the numbers to enter frequency. • • 5 Tap to confirm. » The radio station is broadcast. Before you start to search for radio stations, you can select radio range. Tap Tap . Tap [Save]. Tap one of the channels 01 to 06 to save the select band. Tap to clear the last entered number. Tap to clear all the entered numbers. Select radio range 1 2 2 3 4 . Tap [Radio range] to toggle tuner sensitivity from normal to high sensitivity.
6 Play English Connect USB device Note Load discs • Ensure that the device contains playable content. You can play video, audio or images stored on the following discs: • DVD video, DVD-R, DVD-RW • VCD • Audio CD, CD-R, CD-RW 1 2 Open the USB door. Insert the USB device to the USB socket. » Play starts automatically. Note • Ensure that the disc contains playable content. 1 Insert the disc into the disc slot with label side facing up. » Play starts automatically.
Skip/search 1 Tap to return to playlist menu. 2 Tap one of below icons to select folder/file: • • • 3 4 Remove the SD/MMC card 1 2 3 Switch to another source. Press the card until you hear a click sound. » The card is now disengaged. : To display all available audio folders/track. : To display all available picture folders/files. : To display all available video folders/files Tap or Tap to start play. to select a folder/track.
Tap the numbers to enter chapter/file number, then tap . • To clear the previous input, tap . • To clear all input, tap . For audio files: 1 Repeat one/all During playing, you can select different repeat mode. For DVD/VCD movie disc: 1 2 3 Tap anywhere except for the upper left corner to display menu on the screen, if necessary. Tap For VCD karaoke: 1 Repeat a section You can repeat a specific section of video file (repeat A-B).
Select audio language For video discs that contain two or more audio channels. 1 During play, tap anywhere except for the upper left corner to display menu on the screen, if necessary. 2 3 Tap Rotate pictures 1 When you view pictures, tap anywhere except for the upper left corner to display menu on the screen, if necessary. to display the 2nd menu. Tap repeatedly. » The audio channel information is displayed on the upper line of the screen.
Disconnect Bluetooth devices 1 To disconnect one device, tap (green) is displayed. » (red). Tip • The device will also be disconnected when the You can make or receive phone calls with Bluetooth-enabled phones through the unit. You can also listen to music from a Bluetoothenabled device. device is moved beyond the operational range. • If you want to reconnect the device to the unit, place it within the operational range.
• • Or tap to dial. [Sim phone book] [Local phone book] to dial number directly, then tap Receive call By default, all incoming calls are received automatically. 1 2 If there is incoming call, [Incoming call...] flashes on the screen. Speak into the Bluetooth microphone. When conversation ends, tap to terminate the call.
In Bluetooth menu, tap . » The option menu is displayed. 8 Adjust sound English 1 Adjust volume 1 Turn VOL clockwise to increase volume. • 2 Tap an option to change the setting. Tip Turn VOL anti-clockwise to reduce volume. Mute 1 During play, press • • You can also adjust Bluetooth settings in the . To turn the sound back on, press again. “Settings” menu. Tip • You can also turn off sound by tapping on the screen.
3 4 Tap Tap • • • • • • or 5 Tap F, R, L, or R to adjust fader/balance value. • [Fade] fader range: +24 to -24. (F = front speaker, R = rear speaker) • [Balance] balance range: -24 to +24. (L = left speaker, R = right speaker) 6 Tap to exit. to select an EQ. or to adjust below settings: [Bass] bass range: -14 to +14 [Mid] middle range: -14 to +14. [Treb] treble range: -14 to +14 [LPH] low pass filter range: 60, 80, 100, 200. [MPF] middle pass filter range: 500, 1K, 1.5K, 2.5K.
General settings [Radio region] Options Description Select one that matches your location. [Radio range] [USA], [S. Amer-1], [Arabia], [China],[S. Amer-2], [Europe], [Korea], [OIRT] [Local] Only stations with strong signals can be broadcast. [Distance] Stations with strong and weak signals can be broadcast. [off] Never turn on the screen saver. [10s] Turn on the screen saver automatically 10 seconds after last operation. [20s] Turn on the screen saver automatically 20 seconds after last operation.
[Beep] [On] [Off] [WallPaper] [Blue] [Black] [Red] [F1] [Calibration] 4 Tap Turn on the beep sound. Each time you press a button, the unit beeps. Turn off the beep sound. Turn background color to blue. Turn background color to black. Turn background color to red. Select F1 picture as wall paper. Calibrate the touch screen. 5 • Only picture saved in 800 x 480 pixel (resolution) and in .bmp format can be used as wallpaper. Adjust sound settings 1 Tap [Sound]. to exit.
[Parking] [On] [Off] 2 [DivX registration code] When you drive in reverse, the rear view is displayed in mirror. Disable video view during drive. Enable video view during drive. View code for DivX registration. Tap an option repeatedly to select: Video settings [Aspect ratio] [Video input] [Rear camera] Options [Full] Description For widescreen display. [Normal] For normal display. [Auto] The correct format is set automatically.
[Off] [Pairing code] 3 Tap Answer phone call manually. Set code for pairing the car entertainment system with other Bluetooth devices. The default code is 0000. Language settings [DVD subtitle] to exit. Adjust language settings 1 Tap [Language]. [Disc menu] 3 2 Tap an option repeatedly to select: Language settings [OSD] [DVD audio] 26 EN Options Description [English] Select on-screendisplay language. [ࣇບሱ༵] [ڰບሱ༵] [English] Select DVD audio language.
You can set different volume for different modes. 1 Tap [Volume]. » The volume setting sub-menu is displayed. 2 Tap on a source. • [DVD]/[USB]/[SD] • [CMMB] • [Radio] • [Bluetooth] • [AV-IN1] • [AV-IN2] 3 Tap or to assign value: 0 to 12. » When switches to the source, the volume increases automatically. 4 Press to exit. Adjust DVD rating 1 Tap [DVD rating]. 2 Tap an option repeatedly to select: DVD rating Options Description [Set Set password to password] restrict the play of discs.
10 Others Listen to other devices You can connect an external audio/video device to the unit. 1 Connect the car audio to the device with the supplied AV cable. Tip • When the unit is reset, all the settings remain unchanged. Replace fuse If there is no power, the fuse may be damaged and need to be replaced. 2 3 4 Tap to display the main menu. 1 2 3 Take out the unit from dashboard. 4 Replace the fuse. Check the electric connection.
Note • Product information is subject to change without prior notice. Disc player System Frequency response Signal/noise ratio Total harmonic distortion Channel separation Video signal format Video output English 11 Product information DVD / CD audio / MP3 system 20 Hz - 20k Hz >75dB Less than 1% >55dB NTSC only 1 +/- 0.
Bluetooth Communication Bluetooth Standard system version 2.0 Output Bluetooth Standard Power Class 2 Maximum Line of sight approx. 8m communication range Frequency band 2.4 GHz band (2.4000 GHz - 2.4835 GHz) Compatible Hands-Free Profile (HFP) Bluetooth Handset Profile (HSP) Advanced Audio profiles Distribution Profile (A2DP) Audio Video Remote Control Profile (AVRCP) SBC (Sub Band Codec) Supported SBC (Sub Band Codec) codecs Receive Transmit Compatible USB devices: • USB flash memory (USB 2.0 or USB1.
Warning • Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power • Car engine has not been started. Start the car engine.
• The system is already connected with another Bluetooth-enabled device. Disconnect that device or all other connected devices and then try again. The paired mobile phone connects and disconnects constantly. • The Bluetooth reception is poor. Move the mobile phone closer to the system or remove any obstacle between the mobile phone and the system. • Some mobile phones may connect and disconnect constantly when you make or end calls. This does not indicate any malfunction of the system.
English S SD Secure Digital. A type of memory card with a flash memory. SDHC Secure Digital High Capacity (SDHC) is a type of flash memory card based on the SDA 2.00 specification. The SDA 2.00 specification enables SD cards to reach higher capacities from 4GB to 32GB, and growing. W WMA (Windows Media Audio) An audio format owned by Microsoft, is a part of Microsoft Windows Media technology.
© 2010 Koninklijke Philips Electronics N.V. All rights reserved. CID2280_00_UM_V1.
