User manual

14
Note
Skip this step if the unit is not fi xed by sleeve •
but by supplied screws.
6 Place the supplied rubber cushion over
the end of the mounting bolt.
7 Slide the unit into the dashboard until you
hear a click sound.
8 Reconnect the negative terminal of the
car battery.
Attach the front panel
1 Attach the trim plate to the main unit.
2 Insert the right side of the panel in the
chassis until it is correctly engaged.
3 Push the left side of the panel and point
the left hole at the left pillar.
4 Release the panel to engage the left side.
5mm
If the car battery is not disconnected, •
to avoid short-circuit, ensure that
bare wires do not touch each other.
2 Remove the two screws on the top of the
unit.
3 Remove the mounting sleeve with the
supplied disassembly tools.
4 Ensure that car dashboard opening is
within these measurements:
183 mm
53mm
5mm
5 Install the sleeve into the dashboard and
bend the tabs outward to fi x the sleeve.
EN