User manual

11
Connector Connect to
1 ANTENNA Antenna
2FRONT LINE
OUT R (Socket)
Front right
speaker
3FRONT LINE
OUT L (Socket)
Front left
speaker
4 REAR LINE
OUT R (Socket)
Rear right
speaker
5 REAR LINE
OUT L (Socket)
Rear left
speaker
Tip
The pin arrangement for the ISO connectors •
depends on the type of vehicle you drive. Be
sure to make proper connections to prevent
damage to the unit.
Mount into the dashboard
1 If the car does not have an on-board
drive or navigation computer, disconnect
the negative terminal of the car battery.
If you disconnect the car battery in •
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
If the car battery is not disconnected, •
to avoid short-circuit, ensure that the
bare wires do not touch each other.
2 Ensure that car dashboard opening is
within these measurements:
1 Green/black strip Left speaker
(Rear)
2 White/black strip Left speaker
(Front)
3 Gray/black strip Right speaker
(Front)
4 Purple/black strip Right speaker
(Rear)
e RED Ignition key +12V DC
when ON/ACC
f BLUE Motor/electric antenna
relay control lead/
Amplifier relay control
lead
gBLACKGround
h YELLOW To the +12V car battery
which is energized at all
times
3 Connect the antenna and amplifier as
illustrated, if applicable. You can connect
the car audio to the amplifier through
RCA-TO-RCA cables (not supplied).
b
a
c
d
aa
b
c
d
a
b
e
f
c
d
g
h
b
c
d
English
EN