Always there to help you Register your product and get support at www.philips.
Contents 1 Important Safety Notice 2 Your in-car entertainment system Introduction What's in the box Overview of the main unit Overview of the remote control 3 Get started Install the car audio Mount into the dashboard Attach the front panel Install remote control battery Turn on Set date and time 4 Play audio/video/picture Load discs Connect USB device Insert SD card Remove the SD card.
Set rear view camera Adjust display design Listen to other devices Detach the front panel Reset Replace fuse 23 23 23 23 24 24 13 Product information 24 14 Troubleshooting 25 Playability information About the Bluetooth device 4 EN 25 26
1 Important Safety • • • • • • • • • • • • • • • • Read and understand all instructions before you use the device. If damage is caused by failure to follow instructions, the warranty does not apply. Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. The device is designed for negative ground (earth) 12 V DC operation only. To reduce the risk of traffic accidents, do not watch video when driving.
When you see the crossed-out wheel bin symbol attached to a product, it means the product is covered by the European Directive 2002/96/EC: Never dispose of your product with other household waste. Please inform yourself about the local rules on the separate collection of electrical and electronic products. The correct disposal of your old product helps prevent potentially negative consequences on the environment and human health.
Overview of the main unit ab c d e g f h i j k o n m l q a b c d e f OPEN Open/Close TFT screen. • • • • • • • Press to answer a call. Press and hold to transfer call. / Turn the unit on or off. Confirm selection. Mute or unmute sound. Rotate to adjust volume. BAND • Select tuner band. +/-PRESET • Select preset radio station. • Search for track/folder. DISP p • • g h i j k l m • Adjust dimmer settings. Press and hold to turn off TFT display. TILT Adjust position of the screen.
n o p q • • Press to terminate call. / • Tune for radio station. • Skip/search for track. • Fast backward/forward playback. RESET • Reset the unit when it hangs up. SD/SDHC card slot h i j k l Overview of the remote control a b c m d n o ~ } | e p f q g h i r y j k s x l { z w v u m n t o s p r q t u v w x a b c d y • Turn the unit on or off. NAVI • Enter GPS navigation system. SOURCE • Select source. • g Mute or unmute sound. BAND • Select tuner band.
3 Get started 1 Check the car's wiring carefully, then connect them to the ISO wires. Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Install the car audio These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment.
Caution •• To avoid any accident, the driver must not watch video while driving.This unit is designed to not allow watching moving video while driving. Park your car in a safe place and engage the parking brake before watching moving video. Note •• The video blocking system under parking brake not engaged only control the display of this unit, and will not affect the video output through the rear RCA video output.
Note m 5m •• If the unit is fixed by the supplied screws instead of the sleeve, skip this step. mm 53mm 183 Attach the front panel 1 Attach the trim plate. 2 Insert the left side of the panel in the chassis until it is correctly engaged. Press the right side of the panel until the mechanism locks it into place. • 3 Since the unit cannot be used if the slant angle of dashboard opening is above 20 degrees, ensure that the horizontal slant of the dashboard opening is between 0 and 20 degrees.
2 Insert one CR2025 battery with correct polarity (+/-) as indicated. Close the battery compartment. 3 2 Tap 3 Tap . »» The setup menu is displayed. 4 Drag the bar downward with fingertip. »» The date/time setup menu is displayed. 5 6 7 Tap on [Date], [Clock Mode] or [Time]. or to set date/time. Tap to return to main menu. When date/time is set, tap to display the full menu. Turn on Caution •• Risk of road accidents! Never watch videos or adjust settings while you drive.
»» When USB device is disconnected, it plays the previous source. Insert SD card Note 2 To remove the disc, press the button. »» When the disc is ejected, the unit switches to the previous source, if connected. Otherwise, the unit switches to [Radio] mode automatically. •• This device supports Secure Digital High Capacity (SDHC) card. 1 2 Detach the front panel. Insert the SD card into SD card slot. »» Play starts automatically.
2 3 3 Drag along the search bar to display the alphabet pop-up. Release the finger to refresh the list. Tap on the name to start play. 4 5 Select audio track For video discs that contain two or more audio tracks. 1 During play, tap anywhere except for the upper left corner to display the control bar. repeatedly to select audio track. 2 Tap »» The audio channel information is displayed on upper line of the screen.
Zoom You can zoom in pictures for a close view. 1 During view pictures, tap anywhere except for the upper left corner to display the control bar. repeatedly to zoom in/out the picture. 2 Tap Rotate pictures 1 During view pictures, tap anywhere except for the upper left corner to display the control bar. repeatedly to rotate the picture. Tap 2 Store radio stations in memory You can store up to 6 stations in each band.
Select program type Before tuning to RDS stations, you can select program type and let the unit search only for programs of the selected category. Under radio mode, tap . 1 »» The radio option menu is displayed. 2 Tap [PTY list]. »» The PTY list of available program type is displayed. 3 Swipe your finger on screen repeatedly to select an option. »» The setting is changed.
Pairing with unit 1 2 Tap to display home menu. Tap . »» The setting menu is displayed. 3 4 to display Bluetooth setting menu. Tap Tap [New Pairing] to search for Bluetooth device with your device. Select the name of desired device in the pairing list. Enter default password "0000" in your device. »» iI the pairing succeeds. the phone call record is displayed. 5 6 GPS Card 4 5 Close the card door. Attach the front panel. Tip •• You can press NAVI to enter/exit the navigation system.
3 Make a call When conversation ends, tap the call. (red) to terminate You can make phone call with the unit under any mode. Tip Note •• You can also press terminate the call. •• Ensure that the phone is connected to the unit via Bluetooth. 1 Tap on top of the screen. »» The dial screen is displayed. / on front panel to answer/ Switch phone call to mobile phone If you do not want your passenger to hear your incoming call, you can switch the call the mobile phone. During talking, tap .
9 Play iPod Compatible iPod/iPhone The car audio system supports below iPod/iPhone models: 3 Tap on desired number to start calling. Adjust Bluetooth settings 1 2 In the Bluetooth menu, tap . »» The option menu is displayed. • • • [New Pairing]: pair the new device. [Paired Device]: display paired device. [Display Design]: change the background. Tap an option to change the setting. Made for.
• Unit control mode: tap screen on car audio to control the music. Search for a track During play from iPod/iPhone, you can search through the music/video files to select preferred file for listening/watching. 1 During playing, tap . »» Search list is displayed. 2 3 4 Tap to select folder/file. Tap on the screen to select desired song. Tap on the selected song to play. 2 3 Charge the iPod/iPhone When the iPod/iPhone is connected to the car audio system, the iPod/iPhone begins to charge.
4 Tap 1/2/3 on the screen to adjust full sound setting. Tip •• You can also tap on the upper line of the screen to activate the full sound. • 5 [Subwoofer]: tap [On]/[Off] on screen to turn the subwoofer on or off. • Tap or to select subwoofer volume: 0 to 12. • [LPF]: tap screen to select subwoofer low pass filter range: 80, 120, 160. to exit. Tap Turn MAX sound on/off During play, tap on the upper line of screen. • (red): turn maximizing sound (MAX sound) on.
General settings Options Description [Radio Region] Select one that matches your location. [Beep] [On] [Off] [Language] Turn the beep sound on. Each time you press a button, the unit beeps. Turn off the beep sound. [Navigation Program Path] [Navigation Voice] [Navigation Voice Gain] Select OSD (on screen display) language. [Calibration] Calibrate the touch screen. [Clock Mode] [12Hr]/ Select time format. [24Hr] 3 Access the Navigation Program Path mode. [On] Turn the navigation voice on.
12 Others Adjust brightness 1 2 AV IN Press DISP on front panel repeatedly to adjust the dimmer settings. Press and hold DISP to turn off the display, press again or tap on TFT screen to switch on. Set rear view camera If you connected a rear view camera, you can see from the screen of the car audio system what the camera takes when the back lamp lights up. »» Picture from rear camera is displayed. 2 3 4 Tap to display home menu. [AV-IN1].
13 Product information Note •• Product information is subject to change without prior notice. General Power supply 12 V DC (11 V - 16 V), negative ground Fuse 15 A Suitable speaker impedance 4-8 50 W x 4 channels Maximum power output Tip •• When the unit is reset, all the settings remain unchanged. Continuous power output 24 W x 4 channels (4 10% T.H.D.) Pre-Amp output voltage 4.0 V ( CD play mode; 1 kHz, 0 dB, 10 k load) Subwoofer output voltage 4.
Bluetooth Communication system Bluetooth Standard version 2.0 Output Bluetooth Standard Power Class 2 Maximum communication range Line of sight approx. 8m Frequency band 2.4 GHz band (2.4000 GHz 2.
About the Bluetooth device Music playback is unavailable on the system even after successful Bluetooth connection. •• The device cannot be used with the system to play music. The audio quality is poor after connection with a Bluetooth-enabled device. •• The Bluetooth reception is poor. Move the device closer to the system or remove any obstacle between the device and the system. Cannot connect with the system. •• The device does not support the profiles required for the system.
Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N.V. All rights reserved. CED780_12_UM_V2.
