User manual

8 EN
4 Get started
Caution
Risk of car accidents! Never watch video or operate
this system while driving.
Preparetheremotecontrol
Forthersttimeuse
Pull the protective sheet out.
» The remote control is ready for use.
Replace the battery
Caution
Risk of explosion! Keep batteries away from heat,
sunshine or re. Never discard batteries in re.
Note
Remove the battery if it is exhausted or if the remote
control is not to be used for a long time.
Batteries contain chemical substances, they should be
disposed of properly.
Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
1 Pull out the battery tray.
2 Insert one CR2025 battery with correct polarity (+/-)
as indicated.
3 Insert the battery tray.
Turn on
Press .
» PHILIPS logo and a progress bar are displayed
while boot-up.
To turn off the system, press and hold for
3 seconds.
Forthesttimeuse
After successful boot-up, the following interface is displayed.
1 Tap to select a language for on-screen display.
» The following interface is displayed.
2 Tap to select a radio region that matches your location.
» The following interface is displayed.
3 Tap [Finish] to complete the initial setup.
» The device switches to radio mode automatically.