User manual

7
English
EN
ISO male
connectors
Connect to
i Yellow strip To the +12V car
battery which is
energized at all
times
2 Connect the antenna and amplier as
illustrated, if applicable.
Sockets on rear panel External
sockets or
connectors
1 For ISO male connectors As indicated
above
2 SUB-W OUT (blue
socket)
sub-woofer
3 REAR OUT L (white
socket)
Rear right
speaker
4 REAR OUT R (red socket) Rear left
speaker
5 FRONT OUT R (red
socket)
Front right
speaker
6 FRONT OUT L (white
speaker)
Rear left
speaker
7 ANTENNA Antenna
8 OE SWC IR REMOTE IN
(purple connector)
Ground
9 External Mic (black
connector)
External
microphone
abcd
eg f
h
i
Tip
• The pin arrangement for the ISO connectors depends
on the type of your vehicle. To avoid damage to the
unit, connect properly.
Mount into the dashboard
• If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If the car battery is not disconnected, to
avoid short-circuit, make sure that the bare
wires do not touch each other.
1 Make sure that the car dashboard opening
is within these measurements:
2 Remove the mounting sleeve with the
supplied disassembly tools.
183 mm
53mm
5mm