User manual

21
English
EN
Reset the system
If the system works abnormally, reset the
system to factory default settings.
1 Detach the front panel.
2 Press the RESET button with the tip of a
ball-point pen or toothpick.
» All settings are reset to factory default.
Replace the fuse
If there is no power, check the fuse and replace
it if it is damaged.
1 Check the electric connection.
2 Remove the damaged fuse from the rear
panel.
3 Insert a new fuse with the same
specications (15 A).
Note
• If the fuse gets damaged immediately after it is
replaced, an internal malfunction may occur. In such
case, consult your Philips retailer.
12 Product
information
Note
• Specications are subject to change without prior
notice.
General
Power supply 12 V DC (11 V - 16
V), negative ground
Fuse 15 A
Suitable speaker
impedance
4 - 8
Maximum power
output
50 W x 4 channels
Continuous power
output
22 W x 4 RMS (4
10% T.H.D.)
Pre-Amp output
voltage
2.0 V
Aux-in level 500 mV
Dimensions
(W x H x D) 188 x 58 x 110 mm
Weight 0.63 kg
Radio
Frequency range
- FM
87.5 - 108.0 MHz
(100kHz per step in
auto search and 50kHz
per step in manual
search)
Usable sensitivity -
FM (S/N = 20 dB)
8 µV
Frequency range -
AM(MW)
522 - 1620 KHz (9 kHz)
530 - 1710 kHz (10
kHz)
Usable sensitivity -
AM(MW) (S/N =
20 dB)
30 µV