xp CDR 600/17 English 20-03-2001 13:27 Pagina 1 Audio CD Recorder Hookup Pages CDR- 700 Toll Free Help Line Ligne d’assistance en service libre Linea de ayuda telefónica sin cargo 800-531-0039
CONTROLS AND CONNECTIONS English 34 5 67 8 9 0 # ! @ $ % ^ & * ( ) ¡ ™£ EASY JOG CDR 778 AUDIO CD RECORDER OPEN / CLOSE PLAY/ PAUSE STOP TYPE RECORDING RECORD FINALIZE REM ERASE EXT SOURCE REC TIME TOTAL TIME STORE/MENU CANCEL/DELETE CDR PLAY/ PAUSE STOP OPEN / CLOSE CD ENTER CDR 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 + RECORD PROG CD OPTICAL I I CD CD RW AUDIO CD PLAYBACK PUSH DOWN TO OPEN POWER ON/OFF IR SENSOR DOUBLE SPEED 1 ≤ 2 PUSH DOWN T
DISPLAY CD CDR L L MAINS OUT OUT ANALOG DIGITAL 2 CDR CD CDR R IN OUT ANALOG 34 CDR L R R 1 CDR CD English CONTROLS AND CONNECTIONS IN OUT DIGITAL 5 6 7 IN OPTICAL 8 Connections at the back 1 Connection to power supply 2 ANALOG OUT ............connects CD player deck to the line input of an amplifier (left and right) 3 DIGITAL OUT CD ......connects CD player deck to the digital coaxial input of e.g. amplifier or recording device 4 ANALOG IN ................
INSTALLATION MENU messages - See Menu mode REM REC TIME TRACK TOTAL REM TRACK TIME Connections general STEP EASY JOG SYNC MANUAL DIGITAL I OPTICAL I ANALOG STORE/MENU CANCEL/DELETE RECORD CD RW CHANGER CD RW PROG SHUFFLE ALL REPEAT SCAN TRACK ENTER For playback on the CD recorder (and/or CD player deck) the following outputs are present: - Digital coaxial output (CD & CDR); - Analog output (CD & CDR). We advise you to connect these to the TAPE or CDR input on your amplifier.
INSTALLATION English Analog connections CD recorder & CD player Analog connections CD player deck This connection must be made for playback on the CD recorder deck as well as the CD player deck (cable 2). Cable 1 is only required if you want to make recordings from an external analog source. This connection is only required if you want to playback on the CD player deck separately from the CD recorder deck. This will be the case in DJ-mode. Use the audio cables supplied.
Digital coaxial connections CD recorder Digital optical connections CD recorder This connection is only required if you want to make recordings from an external CD player with a digital coaxial output. This connection is only required if you want to make recordings from an external CD player with a digital optical output. English INSTALLATION Use the digital coaxial cable supplied.
INSTALLATION English Power supply Inserting batteries in the remote control 1 Plug the power cord supplied into the MAINS connector on the CD recorder, then into a mains socket. 2 Press POWER ON/OFF. ➜The recorder is now in Standby mode (Red led on). It takes approximately 2 seconds for the led to light up after pressing POWER ON/OFF. Note: - If the CD recorder is in Standby mode (red led on), press any key to activate the recorder. - The CD recorder will automatically adjust to the local mains voltage.
