Operating instructions

ENGINE ELECTRICAL
Typical Exciter, Pulser or Lighting Coil Replacement
1. Remove coil retaining screws and spacers.
2. Using a pliers, remove epoxy from solder jOints (A)
on the coil to be replaced.
3. Unsolder connection from coil.
4. Clean solder terminals (8) on the replacement coil
and re-solder to their proper wires. NOTE: Always
position with numbers towards the outside.
5. Reinstall retaining screws and spacers.
6. Using a moisture-proof sealant, seal solder joints
as shown.
NOTE: All soldering must be done using
rosin core
solder.
7. Test resistance of each coil prior to stator plate
installation.
NOTE: Lighting and pulseless coils are replaced in a
similar manner.
IMPORTANT: After the stator plate is reinstalled on the
engine, check placement of all coil leads to prevent
possible contact with the flywheel.
8/94
4.28