GENERAL INFORMATION sissified Table of contents GENERAL INFORMATION Maintenance . Technical data CONTROLS AND CONNECTIONS Controls on the front. Connections at the hack INSTALLATION AND REMOTE CONTROL Accessories .. Connections Usual connection, LINE OUT Digital connection, DIGITAL OUT {CD 723 only) Mains Remote control {C0 723 only).. PLAYBACK Playing CD... Sleeting a track and searching Selecting & track during CD play ..
CONTROLS AND CONNECTIONS Contrails on the front POWER ON / STANDBY .. switches the CD player on and to standby [2] OPEN-CLOSE pens and closes the CD tray (3] Sensor for the infrared remote control {4] Display .switches through the different time information [6] REPEAT ...Repeats a track, a program ar the entire CD ...
INSTALLATION AND REMOTE CONTROL ysyibug ]Accessories This CD player is supplied including: —a remote control (CD 723 only} — 2 batteries for the remote control {CD 723 only} ~ & connection cable —this instruction booklet Connections Usual connection, LINE OUT 1 Insert the red plug of the supplied connection cable into R and the other plug into L. 2 Insert the other side of the cable into the corresponding sockets of the GO or AUX input of your amplifier.
PLAYBACK Playing a CD 1 \Use POWER ON / STANDBY to switch on the CD player. 2 Press OPEN-CLOSE to open the CD tray. appears on the display. 3 Insert an audio CD {printed side up) and press OPEN-CLOSE to close the CO compartment. —»READING appears on the display. Then the number of tracks and the playing time is shown, & Press PLAY » to start CD play. —»The display shows -, Track, Tim, and the number and time of the actual track. « You can interrupt CD play by pressing PAUSE 1.
ADDITIONAL FUNCTIONS [ ysijbug Clearing the program | Programming track numbers You can select a number of tracks and store these in the memory in the desired sequence. You can store any track more than once. At most, 30 tracks can be stored in the memory. 1 Press PROGRAM to start programming. —» PROGRAM flashes. Note: If you press PROGRAM wheels playing a CD, the actual track will be added to the program. 2 Press PERV. e or NEXT w1 {PERV. 1 or NEXT »3 on the remote control} to select the desired track.
ADDITIONAL FUNCTIONS 0 Fading out and in You can fade out and in CD play, e. . to stop and strata recording softly. 1 Press FADE during CD play to fade out. The display shows &. in steps. The volume is lowered continuously until CD play is paused. 2 Press FADE again to fade in. ~» The display shows n steps. CD play starts and the volume is raised continuously to its previous level. Note: Yau may use FADE anytime when CD play is paused to fad in.
ADDITIONAL FUNCTIONS fuggy Recording setup iris possible to set up the CD player in a way that it will calculate which tracks will fit on your recording media, It is ably possible to use the edit function if a disc has not more than 28 tracks. If you use NORMAL the recording stops after the last track that fits an one side of your recording media. Notice that Recyclables are single-sided only! if you use OPTIMAL some tracks will be skipped to minimize the unused space on your recording media.
TROUBLESHOOTING WARNING If 2 fault accursed, first check the pants listed below before taking the set for repair. Under no circumstances shooed you try to repair the LD player yourself as this will invalidate the [ you are unable to solve a problem by following this guarantee. checklist, consult your dealer or service center. Problem Possible cause Solution No power Mains cable is not securely connected, Connect mains cable properly. No or bad sand €D 723 only: volume is too fow. Adjust volume.
