Register your product and get support at www.philips.
Important safety instruction • Use only the power supply listed in the technical data. • Do not allow the product to come into contact with liquids. • Risk of explosion if battery is replaced by an incorrect type. Earpiece REDIAL/C MENU/OK In call 1 • Dispose of used batteries according to the instructions.
2 Get started Configure your phone 1 The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. 2 When using your phone for the first time, you see a welcome message (country dependent). 3 Set the country and language if prompted. 4 Set the date and time. • If the time is in 12-hour format, press / key to select [am] or [pm]. Charge your phone Charge 8 hours Place the handset on the base station to charge the handset.
3 Enjoy Call • To make a call, press and dial the phone number. • To answer a call, press when the phone rings. • To end a call, press . Adjust the earpiece volume Press or to adjust the volume during a call. Phonebook Add record 1 Press MENU/OK, then select [Phonebook] > [Add new], then press MENU/OK to confirm. 2 Enter the name, then press MENU/OK to confirm. 3 Enter the number, then press MENU/OK to confirm.
Technical data Battery • CORUN: 2 x AAA NiMH 1.2V Rechargeable 600mAh batteries • GPI: 2 x AAA NiMH 1.2V Rechargeable 600mAh batteries • BYD: 2 x AAA NiMH 1.2V Rechargeable 600mAh batteries • SANIK: 2 x AAA NiMH 1.2V Rechargeable 600mAh batteries Adapter Base and charger: • Philips: SSW-1920UK-2: Input: 100-240V 50/60Hz 0.2A; Output: 6V 500mA • Philips: S003PB0600050: Input: 100-240V 50/60Hz 0.
Frequently asked questions No signal bar displays on the screen. • The handset is out of range. Move it closer to the base station. • If the handset displays [Unregistered], put the handset on the base until the signal bar appears. If I fail to register the additional handsets to the base station, what do I do? Your base memory is full. Unregister the unused handsets and try again. No dialing tone • Check your phone connections. • The handset is out of range. Move it closer to the base station.
