black film width 148 mm AQ 6688 /00 - page 1 AQ 6688 Stereo Radio Cassette Player DYN AMIC AQ66 BASS 88 ST EREO BOO RADI O CA ST SSET TE PL AYER RAD IO ON•O FF 5 BAN D 4 6 SE SEC C ET EN TE R LO LOCK CK DOL PRES 3 7 FM FM LOC K 1 REV ERS E D DIR IRE EC CTT A AC CC 20 CE 20 S ES SS STA S TU TATI TUN TIO NIN ON ING NP G PR RE ES SE ETS TS MH MH..
INDEX n Norge English Typeskilt finnes på apparatens underside. Observer Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten. i Italia ................................................................... 4 Français .............................................................. 11 Español ............................................................... 18 Deutsch ....................................................
AQ 6688 /00 - page 3 FAST WIND 11 REWIND 22 STOP 9 direction 1 2 PLAY 1 2 DC 3V ->+ RESET RADIO ON-OFF DYN AMIC AQ66 BASS 88 ST EREO BOO RADI ST O CA SSET TE PL AYER RAD IO ON•O FF BAN D TUNING ENTER 6 SEC PRES ET 7 FM LOC K TIM E SE T 2 REV ERS E MH.
AQ 6688 /00 - page 4 POWER SUPPLY English Mains adapter The voltage of the 3V adapter must match with the local voltage. The 3.5 mm adapter plug’s 1.3 mm centre pin must also be connected to the minus pole -. • Connect the mains adapter to the set’s DC 3V socket. • Always disconnect the mains adapter if you are not using it. Battery (optional) • Open battery door and insert two alkaline batteries, type R6, UM3 or AA as indicated.
AQ 6688 /00 - page 5 Reset button Should you receive external interference e.g. static electricity from carpets, thunderstorms, etc. which affects the display and electronic functions of your set, the reset button allows you to clear all data (e.g. tuning step, presets) from your set and to start up again. • Use a ball point pen to press the RESET button, found on the back of the cassette door.
AQ 6688 /00 - page 6 SETTING THE CLOCK English CHANGING THE TUNING STEPS AND 12/24-HR CLOCK In North and South America the frequency step between adjacent channels in the AM (MW) band is 10 KHz. In the rest of the world this step is 9 KHz. Usually the frequency step has been preset in the factory for your area.
AQ 6688 /00 - page 7 TUNING Direct Access tuning The frequency of the station you wish to tune to must be known. You can find these frequencies in station tables or radio guides. 1 In the radio mode, press ENTER. ™ The current frequency in the display disappears. 2 Use the Preset memory buttons to enter the digits of your desired frequency within a 5 second period. 3 Press ENTER again to confirm your radio station. ™ The display shows the selected frequency or the nearest frequency.
AQ 6688 /00 - page 8 RADIO RECEPTION English Finding your Preset station 1 Preset RADIO ON-OFF once or more to select the desired waveband. 2 Press the preset number of your desired station. Erasing the Preset Memory by RESET Use a ball-point pen to press the RESET button. ™ You will hear a click to indicate that all preset stations stored and the last station tuned to have been cleared. All settings must now be reprogrammed into the memory.
AQ 6688 /00 - page 9 Accessories (included) 1 x AY 3660 stereo headphones, 1 x Belt clip Using the Belt Clip 1 To attach the belt clip, position the shaped grip on the reverse so that it fits into the belt clip hole. 2 Simultaneously, press and turn the clip to LOCK as indicated on the set. 3 To detach, gently lift the belt clip and turn to RELEASE as indicated on the set. TAKE CARE WHEN USING HEADPHONES Hearing Safety: Listen at a moderate volume.
AQ 6688 /00 - page 10 TROUBLESHOOTING English If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate your guarantee.
