Always there to help you Register your product and get support at www.philips.
Contents 1 Important 2 Safety Notice 2 3 2 Your Micro Music System Introduction What's in the box Overview of the main unit Overview of the remote control 3 Get started Connect speakers Connect FM antenna Connect power Prepare the remote control Demonstrate the features Power on Set the clock Select a source 5 5 5 6 7 9 9 9 9 10 10 10 10 11 4 Play 12 5 Listen to the radio 15 6 Adjust sound 17 Play from disc Play from USB Control play Skip tracks Program tracks Play from Bluetooth-enabled d
1 Important Safety Read and understand all instructions before you use this micro music system. If damage is caused by failure to follow the instructions, the warranty does not apply. Warning •• Never remove the casing of this apparatus. •• Never lubricate any part of this apparatus. •• Never look into the laser beam inside this apparatus. •• Never place this apparatus on other electrical equipment. •• Keep this apparatus away from direct sunlight, naked flames or heat.
Warning •• To prevent possible hearing damage, do not listen at skateboarding, etc.; it may create a traffic hazard and is illegal in many areas. hight volume levels for long periods. The maximum output voltage of headphone is not greater than 150 mV. Listen at a moderate volume. • Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute.
This symbol on a product means that the product is covered by European Directive 2012/19/EU. This symbol means that the product contains batteries covered by European Directive 2013/56/EU which cannot be disposed of with normal household waste. Inform yourself about the local separate collection system for electrical and electronic products and batteries. Follow local rules and never dispose of the product and batteries with normal household waste.
2 Your Micro Music System Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can: • enjoy audio from discs, USB devices, Bluetooth devices, and other external devices; • listen to radio stations.
Overview of the main unit a l kji a b cd e h g f k • • Turn on the product. Switch to standby mode or ECO power standby mode. b Display panel • Show current status. c d • • • • / Skip to previous/next track. Search within a track/disc. Tune to a radio station. Adjust time. • Start or pause play. e VOLUME knob • Adjust volume. f g • Open or close the disc compartment. • • Stop play. Erase a program. h Disc compartment i • Headphone socket. j AUDIO IN • Connect external audio devices.
Overview of the remote control d a e b r c q p d o n e m l f k j g h i • • • • / Skip to the previous/next track. Search within a track/disc/USB. Tune to a radio station. Adjust time. • Play tracks randomly. f ALBUM/PRESET / • Select a preset radio station. • Skip to previous/next album. g DISPLAY/RDS • Adjust display brightness. • During playback, display the play information. • For selected FM radio stations, display RDS information (if available). h SLEEP/TIMER • Set sleep timer.
q FM/AUDIO IN • Select FM source. • Select AUDIO IN source. r 8 • • /PAIRING Select Bluetooth source. Press and hold for three seconds until you hear a beep sound to enter pairing mode.
3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous laser exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Connect FM antenna Tip •• For optimal reception, fully extend and adjust the position of the antenna. •• For better FM stereo reception, connect an outdoor FM antenna to the FM AERIAL socket. Connect the supplied FM antenna to the FM AERIAL socket on back of the product.
Connect the power cable to the wall socket. Prepare the remote control Caution •• Risk of product damage! When the remote control is Switch to standby mode Press again to switch the product to standby mode. »» The clock (if set) is displayed on the panel. • not used for long periods, remove the batteries. To insert the remote control battery: 1 2 3 Note Open the battery compartment. Insert the supplied AAA battery with correct polarity (+/-) as indicated.
Set the clock 1 2 3 4 In standby mode, press and hold CLOCK for more than two seconds to enter the clock setting mode. »» [24H] or [12H] is displayed. Press / to select 24H or 12H hour format, and then press CLOCK. »» The hour digits begin to blink. Press / to set the hour, and then press CLOCK. »» The minute digits begin to blink. Press / to set the minute, and then press CLOCK. »» The set clock is displayed.
4 Play Play from disc 1 2 3 4 Press CD to select CD source. Press to open the disc compartment. Insert a disc with the label side up. Press to close the disc compartment. »» Play starts automatically. If not, press . Control play Start, pause, or resume play. Stop play. Select an album or a folder. Press to skip to the previous or next track. Press and hold to search backward/ forward within a track. Play a track or all tracks repeatedly. Play tracks randomly(Not applicable for the programmed tracks).
Program tracks This function allows you to program 20 tracks in the desired sequence. 1 2 3 4 5 In stop mode, press PROG to activate the program mode. »» [PRG] (program) and [001 PR 01] are displayed. For MP3 tracks, press album. / to select an Press / to select a track, and then press PROG to confirm. Repeat steps 2 to 3 to program more tracks. Press to play the programmed tracks. »» During play, [PRG] (program) is displayed. To erase the program Press twice.
To disconnect the Bluetooth-enabled device: • Deactivate Bluetooth on your device; or • Move the device beyond the communication range. To pair and connect a second device You can pair and connect a maximum of two Bluetooth-enabled devices to this product actively at the same time. To connect and play from a second Bluetoothenabled device 1 2 3 Press and hold / for three seconds to enter pairing mode. »» The Bluetooth indicator flash blue quickly. Pair and connect a second device to this product.
5 Listen to the radio Tune to a radio station Tip Program radio stations manually 1 2 3 •• Position the antenna as far as possible from TV, VCR, or other radiation source. •• For optimal reception, fully extend and adjust the position of the antenna. 1 2 3 Press FM/AUDIO IN repeatedly to select FM source. Press and hold / for more than two seconds. »» The radio tunes to a station with strong reception automatically. Repeat step 2 to tune to more stations.
6 Adjust sound The following operations are applicable to all supported media. Select a preset sound effect • Press SOUND repeatedly to select a preset sound effect. • Balance(Balance), Clear(Clear), Powerful(Powerful), Warm(Warm), and Bright(Bright). Adjust volume level • • On the remote control, press VOL +/repeatedly. On the main unit, rotate the volume knob. Mute sound • Press 16 EN to mute or unmute the sound.
7 Other features Set the alarm timer Tip •• Alarm timer is not available in AUDIO IN mode. Note •• If CD/USB source is selected, but no disc is placed or no USB device is connected, the FM source is selected automatically. This product can be used as an alarm clock. You can select DISC, USB, Bluetooth or FM as alarm source. Note •• Make sure that you have set the clock correctly. •• If the selected alarm source is unavailable, this product switches to FM mode automatically.
2 3 Press FM/AUDIO IN repeatedly to select AUDIO IN source. Start to play the device (see the device user manual). AUDIO IN 2 Connect the product to power. »» Once the device is recognized, the charging starts. Note •• Philips does not guarantee the compatibility of this product with all devices. Charge your devices With this micro music system, you can charge your external devices, such as your cell phone, MP3 player or other mobile devices.
8 Product information Note notice. Amplifier Maximum 170W 40 Hz - 20 kHz; ±3 dB ≥ 75 dBA < 1% 1 V ± 100 mV RMS 22kohm Sensitivity 2.0 Full Speed 5V, 500mA S/N Ratio Semiconductor 12 cm/8 cm CD-DA, CD-R, CDRW, MP3-CD 24 Bits/44.1 KHz <3% (1 KHz) 20 Hz - 20 kHz (44.1 KHz) ≥80 dBA Bluetooth Bluetooth Version Bluetooth Frequency Band Bluetooth Range V4.0 2.4 GHz ~ 2.
USB playability information Compatible USB devices: • USB flash memory (USB2.0 or USB1.1) • USB flash players (USB2.0 or USB1.
9 Troubleshooting Warning •• Never remove the casing of this device. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.
•• This unit is already connected with another Bluetooth-enabled device. Disconnect that device and then try again. The paired mobile device connects and disconnects constantly. •• The Bluetooth reception is poor. Move the device closer to this unit or remove any obstacle between them. •• Some mobile phones may connect and disconnect constantly when you make or end calls. This does not indicate any malfunction of this unit.
EN 23
2016 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. BTM3360_12_UM_V2.
