User manual Micro music system BTM2560 BTM2585 Register your product and get support at www.philips.
Contents 1 Important Safety Notice 2 Your Micro Music System Introduction What's in the box Overview of the main unit Overview of the remote control 3 Get started Connect speakers Connect power Prepare the remote control Power on Set the clock 4 Play Play from disc Play from USB Control play Skip tracks Program tracks Play from Bluetooth-enabled devices 5 Listen to FM radio Tune to a radio station Store radio stations automatically Store radio stations manually Select a preset radio station 6 Adjust s
1 Important Warning •• Never remove the casing of this apparatus. •• Never lubricate any part of this apparatus. •• Never look into the laser beam inside this Safety apparatus. •• Never place this apparatus on other Read and understand all instructions before you use this micro music system. If damage is caused by failure to follow the instructions, the warranty does not apply. electrical equipment. •• Keep this apparatus away from direct sunlight, naked flames or heat.
Notice Any changes or modifications made to this device that are not expressly approved by Gibson Innovations may void the user’s authority to operate the equipment. Compliance Hereby, Gibson Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/ EU. You can find the Declaration of Conformity on www.philips.com/ support.
Care for your product • Do not insert any objects other than discs into the disc compartment. Do not insert warped or cracked discs into the disc compartment. Remove the discs from the disc compartment if you are not using the product for an extended period of time. Only use microfiber cloth to clean the product.
Overview of the main unit 13 AUDIO IN 12 11 10 9 1 8 2 3 7 4 5 6 a IR sensor b LED indicator • Standby indicator: turns red when this product is switched to standby. • Bluetooth indicator: turns blue to indicate the Bluetooth connection status. c • Switch this product on or to standby. d e • Connect USB storage devices. • Open or close the disc compartment. f Disc compartment g Volume knob • Adjust volume. h Display panel • Show current status.
i • • Press to select a source: DISC, USB, TUNER, AUDIO IN, BT. In Bluetooth mode, press and hold for more than 2 seconds to disconnect the currently connected device and enter pairing mode. Overview of the remote control 1 • Start or pause play. 2 18 • • 3 17 • • • • Stop play. Erase a program. / Skip to previous/next track. Search within a track/disc. Tune to a radio station. Adjust time. • antenna Improve FM radio reception. • Connect external audio devices.
e • • Tune to a FM station. Adjust time. • Select shuffle mode to play tracks randomly. Select repeat mode to play a track or all tracks repeatedly. • f g h i j k l • • / Select a preset radio station. Skip to previous/next album. • Display playback information. • • Set sleep timer. Set alarm timer. • • • Set the clock. View clock information. In standby, press and hold to toggle clock display on or off. • • • Program tracks. Program radio stations. Auto store radio stations.
3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. FM ANT AUDIO IN Always follow the instructions in this chapter in sequence. Connect speakers Note •• Insert the stripped portion of each speaker wire into the socket completely. •• For better sound quality, use the supplied speakers only. 1 2 3 4 For the right speaker, find the sockets on the back of the main unit marked "R".
Prepare the remote control Caution Note •• The product switches to standby mode after 15 minutes inactive. •• To achieve the efficient energy saving performance, unplug any external electronic device from the USB port when the device is not in use. •• Risk of product damage! When the remote control is not used for long periods, remove the batteries. •• Batteries contain chemical substances, so they should be disposed of properly.
4 Play Play from disc 1 2 3 4 Press to select CD source. Press to open the disc compartment. Insert a disc with the label side up. Press to close the disc compartment. »» Play starts automatically. If not, press . BTM2560 BTM2585 Control play / / BTM2560 BTM2585 Play from USB Select a preset sound equalizer. Adjust display brightness. Show playback information. Note •• Make sure that the USB device contains playable audio content. 1 2 10 Start, pause, or resume play. Stop play.
For MP3 disc and USB: 1 2 Press / folder. Press file. to select an album or a / to select a track or a BTM2560 BTM2585 Program tracks This function allows you to program 20 tracks in the desired sequence. 1 2 3 4 5 In stop mode, press activate the program mode. »» is displayed. For MP3 tracks, press an album. Press / then press / to to select to select a track, and to confirm. Repeat steps 2 to 3 to program more tracks. Press tracks.
4 Play audio on the connected device. »» Audio streams from your Bluetooth enabled device to this product. To disconnect the Bluetooth-enabled device: • Deactivate Bluetooth on your device. • Press and hold for 2 seconds to enter pairing mode. 5 Listen to FM radio Tune to a radio station Tip •• Position the antenna as far as possible from TV, or other radiation source. •• For optimal reception, fully extend and adjust the position of the antenna. 1 2 3 Press to select FM source.
Store radio stations manually 1 2 3 4 Tune to an FM radio station. Press to activate program mode. »» ] is displayed. Press / to allocate a number from 1–20 to this radio station, and then press to confirm. 6 Adjust sound The following operations are applicable to all supported media. Select a preset sound effect • Repeat steps 1-3 to program more stations. Adjust volume level Note •• To overwrite a programmed station, store another station in its place.
7 Other features Set the alarm timer This product can be used as an alarm clock. You can select the disc, radio, or .mp3 files on a USB storage device as alarm source. Note •• Alarm timer is not available in AUDIO IN mode. •• If CD/USB source is selected, but no disc is placed or no USB device is connected, the radio source is selected automatically. 1 2 3 4 5 6 14 Make sure that you have set the clock. In standby, press and hold for more than 2 seconds. »» The hour digits blink.
Note •• Compatibility of this product with all devices is not guaranteed. BTM2560 BTM2585 FM ANT AUDIO IN AUDIO IN Charge your devices With this micro music system, you can charge your external devices, such as your cell phone, MP3 player or other mobile devices. 1 2 Use a USB cable to connect the USB socket of this product with the USB socket of your devices. Connect the product to power. »» Once the device is recognized, the charging starts.
8 Product information • • • Note •• Product information is subject to change without prior notice. • • • Specifications • • • • • • • • • • • • • 16 Rated output power (Amplifier): • BTM2560: Total 70W (max.) • BTM2585: Total 80W (max.) Acoustic frequency response: 66Hz - 20KHz Speaker driver: 2 x 4” woofer range, 8Ω; 2 x 20 tweeter range, 8Ω Bass enhancement: 2 x bass port Support disc type: CD-DA, CD-R, CDRW, MP3-CD (8/12 cm) Bluetooth version: V2.1 + EDR Bluetooth supported profiles: A2DP V1.
• • • • Unsupported file formats are skipped. For example, word documents (.doc) or MP3 files with extension .dlf are ignored and not played. WMA, AAC, WAV, PCM audio files DRM protected WMA files (.wav, .m4a, .m4p, .mp4, .aac) WMA files in Lossless format Supported MP3 disc formats • • • • • ISO9660, Joliet Maximum title number: 128 (depending on file name length) Maximum album number: 99 Supported sampling frequencies: 32 kHz, 44.
•• •• •• •• source with the remote control instead of the main unit. Reduce the distance between the remote control and the unit. Insert the battery with its polarities (+/– signs) aligned as indicated. Replace the battery. Aim the remote control directly at the sensor on the front of the unit. No disc detected •• Insert a disc. •• Check if the disc is inserted upside down. •• Wait until the moisture condensation at the lens has cleared. •• Replace or clean the disc.
How to keep clock display on or off in standby? •• In standby, press and hold to toggle clock display on or off.
Copyright © 2017 Gibson Innovations Limited. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. The Philips trademark and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. used under license. BTM2560/2585_12_UM_V1.
