Always there to help you Register your product and get support at www.philips.
Contents 1 Important Important safety instructions 2 2 2 Your portable speaker 3 3 3 3 3 Get started 4 4 4 4 Play from Bluetooth devices 5 5 5 6 5 Play from external devices 7 6 Product information 8 8 8 8 8 7 Troubleshooting 9 9 9 Introduction What's in the box Overview of the speaker Charge the built-in battery Turn on/off Connect a device Disconnect a device Reconnect a device Amplifier Speaker Bluetooth General information General About Bluetooth device 8 Notice Care of the environme
1 Important Warning •• Never remove the casing of this speaker. •• Never lubricate any part of this speaker. •• Never place this speaker on other electrical equipment. •• Keep this speaker away from direct sunlight, naked flames or heat. Important safety instructions a Read these instructions. b Keep these instructions. c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. f Clean only with dry cloth. g Do not block any ventilation openings.
2 Your portable speaker Overview of the speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this speaker, you can enjoy audio from Bluetooth-enabled devices or other external devices.
3 Get started Always follow the instructions in this chapter in sequence. Charge the built-in battery The LED indicator indicates the battery status. "OFF" mode "AUDIO IN" mode "Bluetooth" mode The speaker is powered by a built-in rechargeable battery.
4 Play from Bluetooth devices 3 If you cannot find [Philips BT50] on your device, press and hold PAIRING for more than three seconds until you hear triple beeps. • With this speaker, you can listen to audio from Bluetooth-enabled devices. Note Select [Philips BT50] displayed on your device for pairing and connection. If necessary, input “0000” as the pairing password. »» After successful pairing and connection, the speaker beeps twice, and the LED indicator turns solid blue.
Reconnect a device When you turn on the speaker, it will reconnect the last connected device automatically; If not, select [Philips BT50] on your Bluetooth device to start connection.
5 Play from external devices With this speaker, you can also listen to an external audio device such as an MP3 player. Note •• Make sure that music playback through Bluetooth is stopped. 1 2 3 Connect an audio input cable (not supplied) with a 3.5 mm connector on both ends to • the AUDIO IN socket on this speaker, and • the headphone socket on the external device. Slide the source selector to AUDIO IN. »» The LED indicator turns white. Play audio on the external device (refer to its user manual).
6 Product information Note •• Product information is subject to change without prior notice. Amplifier Rated Output Power Frequency Response Signal to Noise Ratio Audio-in Input 1.5W RMS 100 -16000 Hz, ±3dB > 70 dBA 300 mV RMS Speaker Speaker Impedance Speaker Driver Sensitivity 4 ohm 4cm full range >82dB/m/W± 3dB/m/W Bluetooth Bluetooth Version Bluetooth profile Bluetooth Frequency Brand Bluetooth Range 8 EN V2.1 + EDR A2DP 2.4GHz ~ 2.
7 Troubleshooting Warning •• Never remove the casing of this device. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available. Cannot connect with the device.
8 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Notice for the USA and Canada This device complies with Part 15 of the FCC Rules and license-exempt RSS standard of Industry Canada.
Always bring your product to a professional to remove the built-in battery. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company.
2015 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V. BT50_37_UM_V1.
