Always there to help you Register your product and get support at www.philips.
Contents 1 Important Safety 2 2 2 Your Bluetooth speaker 3 3 3 4 3 Get started 5 5 5 4 Use Bluetooth devices 6 6 6 5 Other features 7 7 7 6 Product information 8 8 7 Troubleshooting 9 9 9 Introduction What's in the box Overview of the speaker Power supply Turn on Play from Bluetooth devices Control your phone call Listen to an external device Adjust volume Specifications General About Bluetooth device 8 Notice 10 EN 1
1 Important Safety Warning •• Never remove the casing of this speaker. •• Never lubricate any part of this speaker. •• Never place this speaker on other electrical equipment. •• Keep this speaker away from direct sunlight, naked flames or heat. Important safety instructions a Read these instructions. l Refer all servicing to qualified service personnel.
2 Your Bluetooth speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this speaker, you can enjoy audio from your Bluetooth-enabled devices, or other external audio devices. What's in the box Check and identify the contents of your package: • Speaker • Power adapter • Short user manual Always there to help you Register your product and get support at www.philips.
Overview of the speaker c b ed a • Turn the speaker on or off. b +/• Adjust volume. c • • • /PAIRING Enter Bluetooth pairing mode. Answer or reject an incoming call. End the current phone call. d AUDIO IN • Connect an external audio device. e DC IN • Connect power.
3 Get started Turn on Always follow the instructions in this chapter in sequence. Press and hold for 2 seconds to turn the speaker on. »» The LED indicator flashes blue. Power supply The Bluetooth speaker can be powered by either AC mains or built-in battery. Option 1: AC power Caution •• Risk of product damage! Make sure that the power voltage corresponds to the voltage printed on the back or underside of the speaker. Connect the power adaptor to: • the DC IN socket on the speaker.
4 Use Bluetooth devices With this speaker, you can listen to audio from Bluetooth-enabled devices and control the incoming call through Bluetooth. Play from Bluetooth devices Note •• Make sure that your Bluetooth device is compatible with this speaker. •• Before pairing a device with this speaker, read its user manual for Bluetooth compatibility. •• The speaker can memorize a maximum of 4 paired devices.
5 Other features Adjust volume During play, press + or - repeatedly to increase or decrease the volume level. Listen to an external device With this speaker, you can also listen to an external audio device such as an MP3 player. Note •• Make sure that there is no Bluetooth connection, or music playback through Bluetooth is paused. Tip •• To increase or decrease volume continuously, press and hold + or - for 2 seconds. •• When the volume reaches the maximum or minimum, the LED indicator flashes twice.
6 Product information General information Power Supply - AC Power (power adapter) Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power Frequency Response Signal to Noise Ratio Audio-in Input 2 X 2W RMS (DC-in mode); 2 X 1.8W RMS (Battery mode) 80 -16000 Hz, ±3 dB >67 dBA 600 mV RMS 20 kohm Bluetooth Bluetooth Version Supported Profiles Bluetooth Frequency Brand Range V2.1 + EDR HFP, A2DP, AVRCP 2.4GHz ~ 2.
7 Troubleshooting Warning •• Never remove the casing of this device. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.
8 Notice Any changes or modifications made to this device that are not expressly approved by Gibson Innovations may void the user’s authority to operate the equipment. Notice for the USA and Canada This device complies with Part 15 of the FCC Rules and license-exempt RSS standard of Industry Canada.
Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Specifications are subject to change without notice. 2015 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. BT3080_37_UM_V2.
