User Guide
English
1 How to use
Before use:
Note
• Only use the brush on dry hair.
• Bristles are hot. Do not touch the bristles nor put the bristles too
close to your hair roots or scalp, to avoid unintended burns.
• Some parts of the brush may be hot. Hold the product by its
handle.
• Remove your ngers when the brush is close to hair ends to avoid
touching the bristles.
• Do not wash the brush under running water.
1 Connect the plug to a power supply socket.
2 Comb your hair thoroughly and divide them into small sections.
3 Slide the temperature switch ( a ) to select your desired setting
according to the table as below.
Hair Type Temperature Setting
Thin / Medium hair
- 170°C
Thick hair
- 200°C
» The indicator ( b ) will keep blinking until the appliance is ready
for use.
To straighten your hair ( Fig.3 )
1 Use a round brush or comb to detangle your hair before using.
2 Select one section of hair and put the heated brush ( c )
underneath the hair strand with bristles facing upwards, about 3cm
away from your hair roots.
3 Hold the selected hair section taut. Slide down the brush slowly to
your hair ends in a single motion and slightly turn in the brush as you
reach the ends to give soft icks to the ends.
4 Allow the section of hair to cool for 2-3 seconds. On the same hair
with brush facing downwards, hold the hair taut and slowly slide
down to your hair ends in a single motion without stopping.
5 Repeat steps 2-4 as necessary until you get your desired results.
6 To turn o the appliance, slide the switch ( a ) to O.
7 Let the hair sections cool down before you nger-comb the hair into
its nal style. For long lasting results, mist with hairspray.
Tips and Tricks
• Flatten the selected section of hair between your ngers before
placing hair on the brush so that hair is spread evenly across the
brush.
• Place selected hair as close as possible to the heated base of the
brush to ensure there is good contact with hair for better styling
results.
After use:
1 Switch o the appliance and unplug it.
2 Place it on a heat-resistant surface until it cools down.
3 Clean the appliance and bristles by damp cloth and use your ngers
to remove hair or dust on the brush.
4 Keep it in a safe and dry place, free of dust. You can also hang it with
the hanging loop ( d ).
2 Troubleshooting
Problem Cause Solution
The
appliance
does not
work at all.
The power socket to
which the appliance
has been connected
may be broken.
Check the appliance is plugged
in correctly.
Check the fuse for this power
socket in your home.
The hair
strand is
not straight
enough
after
styling.
Temperature setting
is too low to reach
the desired style.
Brush your hair when the
indicator stops blinking.
Change temperature setting
to .
Put the selected hair strand
close to the heating base of
the brush.
•
•
•
•
•
1
2
3
a
°C
°C
» b
1
2
c
3
4
5
6
a
7
•
•
1
2
3
4
d
3 CM
a
b
d
c
4 5
1 2 3
A
3 CM