User manual

14
EN
8 Product specifications
Note
• Specicationsanddesignaresubjecttochangewithout
notice.
Amplier
• Total output power: 210W RMS (+/- 0.5 dB,
30% THD) / 168W RMS (+/- 0.5 dB, 10% THD)
• Frequency response: 20 Hz-20 kHz / ±3 dB
• Signal-to-noise ratio: > 65 dB (CCIR) /
(A-weighted)
• Input sensitivity:
• AUX: 750 mV
• AUDIO IN: 400 mV
Audio
• S/PDIF Digital audio input:
• Coaxial: IEC 60958-3
• Optical: TOSLINK
Bluetooth
• Bluetoothproles:A2DP
• Bluetooth version: 2.1 + EDR
Main unit
• Power supply: 110-240 V~, 50-60 Hz
• Power consumption: 50 W
• Standbypowerconsumption:≤0.5W
• Speaker impedance:
• Woofer: 8 ohm
• tweeter: 8 ohm
• Speaker drivers: 2 x 76 mm (3") woofer +
2 x 25.4 mm (1") tweeter
• Dimensions (W x H x D): 1035 x 73 x 156 mm
(with portable left and right speakers attached)
• Weight: 4.4 kg
Portable speakers
• Speaker impedance: 8 ohm
• Speaker drivers: 2 x 76 mm (3") full range
• Dimensions (W x H x D): 191 x 73 x 156 mm
• Weight: 0.86 kg/each
Subwoofer
• Power supply: 110-240 V~, 50-60 Hz
• Power consumption: 30 W
• Standbypowerconsumption:≤0.5W
• Impedance: 4 ohm
• Speaker drivers: 1 x 165 mm (6.5") woofer
• Dimensions (W x H x D): 200 x 510 x 201 mm
• Weight: 4.9 kg
Wall mount
• Dimensions (W x H x D): 40 x 100 x 26.5 mm
• Weight: 0.1 kg/each
Remote control batteries
• 2 x AAA-R03-1.5 V
Standby information
• When the product remains inactive for
15 minutes, it automatically switches to standby
or networked standby.
• The power consumption in standby or
networked standby is less than 0.5W.
• To deactivate Bluetooth connection, press
and hold the Bluetooth button on the remote
control.
• To activate Bluetooth connection, enable
Bluetooth connection on your Bluetooth device,
or enable Bluetooth connection via the NFC tag
(if available).
9 Troubleshooting
Warning
• Risk of electric shock. Never remove the casing of the
product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, get support at
www.philips.com/support.
Sound
No sound from SoundBar speakers.
• Connect the audio cable from your SoundBar to
your TV or other devices. However, you do not
need a separate audio connection when:
• the SoundBar and TV are connected
through HDMI ARC connection, or
• a device is connected to the HDMI IN
connector on your SoundBar.
B5_12_UM_V2.0.indb 14 9/23/2014 1:26:48 PM