Quick Start Guide

www.philips.com/support
AZ330T
Specifications are subject to change without notice
2016 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under the responsibility of WOOX
Innovations (Shanghai) Commercial Company Ltd., and WOOX Innovations (Shanghai)
Commercial Company Ltd., is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips
N.V. and are used under license.
AZ330T_93_QSG_V1.0
EN
Before using your product, read all
accompanying safety information.
ZH-CN
在使用产品之前，请先阅读所有
随附的安全信息。
EN
To play with the device, you can use
either alkaline battery (R14) or AC
power.
ZH-CN
若要使用本装置进行播放，您可
使用碱性电池
(R14)
或
AC
电源。
Quick Start Guide
www.philips.com/support
Always there to help you
Register your product and get support at
Question?
Contact
Philips
6X1.5V R14/UM2/C CELL
AC~MAINS
BT
FM OFF
CD/USB
BT FM OFFCD/USB
USBCD
PROG
MODE
- ALBUM +
PROG
PROG
EN
Program tracks
ZH-CN
编排曲目
EN
The USB input (as a music source)
is meant for data transfer, not for
battery charging purpose.
ZH-CN
该
USB
接口仅用于数据传输，
不具充电功能。
EN
/
Press to skip to the previous/next
track
Press and hold to search within play,
then release to resume play.
Start or pause play.
Stop play.
PROG Program tracks.
+ VOLUME - Adjust volume.
- ALBUM + Skip the the previous or next album.
MODE Select a play mode.
• In CD/USB/BT mode, the CD sound machine
switches to standby mode automatically if there
is no audio signal detected for over 15 minutes.
• Press to wake up your CD sound machine
from standby mode.
ZH-CN
/
按下可跳至上一
/
下一曲目
按住可在播放中搜寻，放开即可
恢复播放。
开始或暂停播放。
停止播放。
PROG
编排曲目。
+ VOLUME -
调整音量。
- ALBUM +
跳过上一张或下一张专辑。
MODE
选择播放模式。
• 在
CD/USB/BT
模式下，若
CD
音响超过
15
分钟未侦测到任何音频信号，即会自动切换
至待机模式。
• 按下 即可唤醒处于待机模式中的
CD
音响。
USBCD
BT FM OFFCD/USB
EN Quick Start Guide
ZH-CN 快速使用指南
Philips AZ330T
BT FM OFFCD/USB
EN
1 Switch the source selector to BT.
» The bluetooth indicator ashes blue.
2 On your Bluetooth device, enable Bluetooth function and search for devices.
3 Select [Philips AZ330T] on your device for pairing. If necessary, enter default
password “0000”.
» After successful pairing and connection, the product beeps twice, and the LED
indicator turns solid blue.
4 After successful Bluetooth connection, play audio on the Bluetooth device.
Note: Press and hold PAIRING for two seconds to disconnect the Bluetooth connection
and enter pairing mode.
ZH-CN
1 将音源选择钮切换至
BT
。
» 蓝牙指示灯会闪烁蓝色。
2 在您的蓝牙装置上，启用蓝牙功能搜索装置。
3 选择装置上的 [Philips AZ330T] 进行配对。 按需要输入预设密码 “
0000
”。
» 成功配对与连接后，产品会发出两次哔声，且
LED
指示灯会持续亮蓝灯。
4 蓝牙连接成功后，在蓝牙装置上播放音频。
注：按住 PAIRING 两秒可中断蓝牙连接并进入配对模式。
Question?
Contact
Philips
Question?
Contact
Philips
AZ330T_93_QSG_V1.0.indd 1 2016/6/23 14:40:04