Specifications

3 - 6
TROUBLESHOOTING No sound /power –
Volume not adjusted
• Adjust the VOLUME –
Mains lead not securely connected
• Connect the AC mains lead properly –
Batteries flat / incorrectly inserted
• Insert (fresh) batteries correctly –
Headphones connected to the set
• Disconnect headphones –
Electrostatic discharge/interference
• Unplug the set. If batteries inserted, remove batteries
from the battery compartment. Press and hold
STANDBY ON y
for 10 seconds, then re-plug /
replace battery supply, and try activating the set again.
• When in USB PC LINK mode, check that your PC's
volume is audible and not set to minimum.
• When playing a CD from the PC's CD-ROM drive, refer
to USB PC Link - Enable digital CD audio output.
–CD contains non-audio files • Press SEARCH or §. once or more to skip to
a CD audio track, instead of the data file
Poor sound quality in GAME
•
AUX mode
• Adjust the volume on the set or on your game console Severe radio hum or noise –
Electrical interference: set too close to TV, VCR or
computer
• Move the set to increase the distance Remote control does not function properly –
Batteries flat/ incorrectly inserted
• Insert (fresh) batteries correctly –
Distance/ angle between the set too large
•Reduce the distance/ angle Poor radio reception –
Weak radio signal
• FM / MW: Adjust the FM / MW telescopic aerial
indication
– CD-R(W) is blank/ not finalized • Use an unfinalized CD-R(W) indication –
No CD inserted
• Insert a suitable disc –
CD badly scratched or dirty
• Replace/ clean CD, see Maintenance –
Laser lens steamed up
•Wait until lens has cleared The CD skips tracks –
CD damaged or dirty
• Replace or clean CD –
shuffle or program is active
• Switch off shuffle / program
is displayed in USB PC LINK
mode for more than 10 sconds –
Check the connection between your PC and the set. If
necessary, please refer to the chapter Connecting to
USB PC Link for the initial setup required.
• Make sure the connected PC is turned on and the
MusicMatch software is working.
Sound skips during MP3 playback – MP3 file made at compression level exceeding
320kbps
• Use a lower compression level to record CD tracks
into MP3 format
–
Disc damaged or dirty
• Replace or clean disc Cannot find desired MP3 title – Wrong file extension used and/ or file name with
unsuitable text characters used
• Make sure the file names are typed in English
text characters an that the MP3 files end with .mp3
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center.
W
ARNING: Do not open the set as there is a risk of electric shock! Under no
circumstances should you try to repair the set yourself, as this will invalidate the warranty.
For more information on operation instruction please visit Philips Audio internet site :
http://www.audio.philips.com
INSTRUCTION FOR USE