MP3-CD Soundmachine AZ1302 Meet Philips at the Internet http://www.philips.
1 2 6 2 1 TUNER MONO STEREO OFF TAPE CD ) ( * & ^ ¡ 5 4 9 8 7 6 3 4 ALBUM/ PRESET 5 6 REMOTE SENSOR PROG SEARCH STOP/BAND PLAY/PAUSE MODE 3 2 1 ALBUM/ PRESET+ 7 DIGITAL TUNIN G 0 ! @ # $ % 2 x R06
8 4 9 # X 5 0 C 6 ! 7 @ B A A
English Supplied accessories – AC mains lead – remote control Top and front panels(See 1) 1 Source selector CD,TUNER, TAPE/OFF – selects CD/MP3-CD, radio or tape source of sound – switches off the set 2 MONO•STEREO – selects mono or stereo FM reception 3 VOLUME – adjusts volume level 4 LIFT TO OPEN – lift here to open the disc door 5 REMOTE SENSOR – infrared sensor for remote control 6 Cassette recorder keys: PAUSE ; – pauses playback or recording STOP•EJECT 9/ – stops playback or recording.
General Operation Digital Tuner General operation 1 2 3 4 • Using AC Mains Check if the mains voltage, as shown on the type plate located on the back of the set, corresponds to your local mains supply. If it does not, consult your dealer or service center. If your set is equipped with a voltage selector, adjust the selector so that it matches with the local power supply. Connect the mains lead to the AC ~ inlet and the wall socket.The mains lead is now connected and ready for use.
CD/MP3 Player CD/MP3 Player CD/MP3 player • • About MP3 The music compression technology MP3 (MPEG1 Audio Layer 3) significantly reduce the digital data of an audio CD while maintaining CD quality sound. Getting MP3 files: you can either download legal music files from the internet to your computer hard disc, or create such files by converting audio CD files in your computer through appropriate encoder software. (128kbps bit rate or higher is recommended for MP3 files.
CD/MP3 Player Reviewing the programme In the stop position, press PROG repeatedly to see your stored track numbers. ➜ Audio CD: a stored track number appears MP3: ALBUM and an album number appear, then a stored track number in the album is displayed – only track number appears if in the same album Erasing the programme You can erase the contents of the memory by: – selecting TUNER or TAPE sound source; – opening the disc door; – in the stop position, press PROG to enter program mode and then, press 9.
Troubleshooting ORIGINAL COPYRIGHT NOTICE If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
