Always there to help you Register your product and get support at www.philips.
Contents 1 Important 4 2 Your CD Soundmachine 5 5 5 5 3 Get started 6 6 7 7 4 Play 7 7 8 8 9 Introduction What's in the box Overview of the main unit Connect power Turn on Turn off Play a CD Play from an external device Play tape Tune to FM radio stations 5 Play options 9 9 10 10 6 Product information Specifications Maintenance 10 10 11 7 Troubleshooting 12 8 Notice 13 Control play Program tracks Adjust sound EN 3
1 Important • • • • • • • • • • • 4 Read these instructions. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the unit.
2 Your CD Soundmachine a DBB • Turn dynamic bass boost on/off. b REPEAT • Play a track or all tracks repeatedly. c d Introduction With this CD Soundmachine, you can: • listen to FM radio; • enjoy audio from discs, tapes, and other external audio devices; • program the play sequence of tracks. The unit offers you Dynamic Bass Boost (DBB) to enrich sound.
3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of your apparatus. The model number and serial number are on the bottom of your apparatus. Write the numbers here: Model No. __________________________ Serial No.
Turn on 4 Play Press . »» When the source selector is in the AUDIO-IN/CD position, is displayed. Play a CD Switch to standby mode • The unit switches to standby mode automatically when there is no audio detected for over 15 minutes. • Press to wake up the unit from standby mode. Turn off Press again. Note •• You cannot play CDs encoded with copyright protection technologies.
Play from an external device You can also listen to an external audio device through this unit. 1 2 3 Switch the source selector to AUDIO-IN/ CD. Connect an audio cable (3.5mm, not supplied) to: • the AUDIO-IN socket on the unit. • the headphone socket on an external device. Play the external device (see the device's user manual). Note •• The AUDIO-IN socket is not for headphones. •• The display panel lights off when the unit plays from the external device.
Tune to FM radio stations 5 Play options Note •• For optimal reception, fully extend and adjust the position of the FM antenna. 1 2 3 Switch the source selector to FM. Rotate TUNING to select a station. Repeat step 2 to tune to more stations. Control play In CD mode, you can control play through the following operations. / PROG +VOLUMEREPEAT SHUFFLE Press:skip to the previous/next track Hold:search within play, then release to resume play. Start or pause play. Stop play. Program tracks.
Program tracks In CD mode, you can program a maximum of 20 tracks. 1 2 3 4 5 Press 6 Product information to stop playback. Press PROG to activate the program mode. »» [PROG] (program) begin to blink. Note •• Product information is subject to change without prior notice. Press / to select a track number, then press PROG to confirm. Repeat steps 3 to program more tracks. Press to play the programmed tracks. »» During play, [PROG] (program) is displayed. • • To erase the program, press twice.
Signal to Noise Ratio >50 dBA Tape deck Frequency response - Normal tape (type I) Signal-to-noise ratio - Normal tape (type I) Wow and flutter 125 - 8000 Hz (8 dB) 35 dBA ≤ 0.4% DIN General Power supply - AC Power - Battery Operation Power Consumption Standby Power Consumption Dimensions - Main Unit (W x H x D) Weight (Main Unit) 220-240V~, 50/60 Hz; 9 V, 6 x 1.5 V type: R14/UM2/C CELL 15 W <0.5 W 299 x 240 x 132 mm 1.
7 Troubleshooting Warning •• Never remove the casing of this device. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available. No power • Ensure that the Mains cord is connected securely.
8 Notice This product complies with the radio interference requirements of the European Community. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. separate into three materials: cardboard (box), paper pulp (buffer) and polyethylene (bags, protective foam sheet.
Specifications are subject to change without notice © 2013 Koninklijke Philips Electronics N.V. All rights reserved. AZ127_12_UM_V1.
