EN User manual
Important 1 Safety Important Safety Instructions a b c d e f g h Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Warning • • • • • • Never remove the casing of this Soundmachine. Never lubricate any part of this Soundmachine. Never place this Soundmachine on other electrical equipment. Keep this Soundmachine away from direct sunlight, naked flames or heat. Never look into the laser beam inside the Soundmachine. Ensure that you always have easy access to the power cord, plug or adaptor to disconnect the Soundmachine from the power.
2 Your CD Soundmachine Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.Philips.com/welcome. Introduction With the CD Soundmachine you can play audio discs and listen to FM/MW radio. You can also program the play sequence of tracks. Dynamic Bass Boost (DBB) helps you to maximizes music enjoyment.
l o m n 1 VOLUME • 2 • 3 Adjust volume level DBB Turn the bass enhancement on/off Cassette recorder buttons • Pause play or record • Stop cassette play or record Open the cassette holder • / Fast forward/rewind cassette • Start cassette play • Start cassette record 4 PROG • 5 • 6 Program tracks and browse the program MODE Select a play mode: REPEAT or SHUFFLE Basic play buttons: •
Stop CD play Erase a CD program • Start or pause CD play • / Select the previous/next track Fast search backwards/forwards within the current track 7 ALBUM +/- • 8 • 9 Skip to the next/previous album in an MP3-CD BAND Select a wave band MP3 LINK • Socket for audio input 10 TUNING +/- • Tune to radio stations 11 LIFT TO OPEN • Open/Close the CD compartment 12 Telescopic antenna • Improve FM reception 13 AC MAINS~ • Socket for the power cord 14 Battery door 15 Source selector: CD, T
1 Open the battery compartment. 6 x 1.5V R-14/UM-2/C-cell 2 3 Insert 6 x 1.5V R14/UM-2/C-cell batteries with correct polarity (+/-) as indicated. Close the battery compartment. Tip • If you want to save battery life, use the supplied power cord. Connect AC power Warning • • Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the Soundmachine.
1 Switch the voltage selector in the battery compartment of the Soundmachine to the local power line voltage. 2 Connect the power cord to the AC MAINS~ socket on the Soundmachine and to the power supply socket. • To switch the Soundmachine off completely, disconnect the power cord from the power supply socket. Tip • To save energy: After use, set the source selector to TAPE/OFF. 4 Use your Soundmachine Play a CD Note • You cannot play CDs encoded with copyright protection technologies.
3 4 5 Insert a CD with the printed side facing up. Close the CD lid gently. » The total number of tracks is displayed. Press to start play. » [ ] is displayed. • • • To pause CD play, press To resume CD play, press . To stop CD play, press . again. Select a track 1 During play, press / to select a track. Select an album For MP3-CDs only. 1 During play, press ALBUM +/-to select an album. Find a passage within a track 1 During play, press and hold / .
• 1 [ ALL] – repeats the entire CD/program During play, press MODE repeatedly until the display shows the repeat icon. Repeat one track. • • • Repeat an album. • Repeat a program. To stop repeat play, press MODE repeatedly until the repeat icon is no longer displayed. Shuffle play You can play all tracks in random order. 1 During play, press MODE repeatedly until the display shows the shuffle icon. • To stop shuffle play, press MODE again.
2 Press ALBUM +/- to select an album. This step is only applicable for MP3-CDs. 3 4 Press 5 / to select a track. Press PROG to store the track. » [PROG] and [P02] are displayed. Repeat steps 2 to 4 to select and store all tracks. » When all 20 tracks are stored, no more tracks can be selected and the display shows [PROG] and [---]. 6 To play program, press . » In stop mode, press PROG repeatedly to browse stored tracks. • To cancel program, press twice.
1 2 During stop, press / To stop fast search, press to search for a desired passage in a tape. . Record from CD 1 2 3 4 5 6 7 Switch the source selector to CD. Insert a CD with the printed side facing up. If you want to record tracks in the desired sequence, program the desired tracks. Press to open the cassette holder. Insert a blank cassette. Close the holder. Press to start to record. » The disc/program starts automatically from the beginning. • .
• Ensure that the power cord is connected securely. • Ensure that there is power at the power supply socket. • Ensure that the batteries are installed correctly. No sound • Adjust the volume. • Ensure that the track played is of a compatible format. Display does not function properly./No reaction to operation of any of the controls. 1 Disconnect the AC power cord. 2 Connect the AC power cord after a few seconds. Cannot play disc • Ensure that the disc label is inserted with the printed side facing up.
© 2008 Koninklijke Philips Electronics N.V. All rights reserved.
