CD Soundmachine Register your product and get support at www.philips.
1 3 1 2 5 6 5 5 8 4 7 9 0 LINE-IN ! 5 @ LIN # E-IN $
2 6 x R14 • UM-2 • C-CELLS %
8 3 4 5 X PROG 6 7 C B A A
English Controls/Power Supply Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
Power Supply 2 Replace the battery door, making sure the batteries are firmly and correctly in place.The set is now ready to operate. • Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst: Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. When inserting new batteries, do not try to mix old batteries with the new ones.
CD Player Playing a CD • • Finding a passage within a track This CD player plays Audio Discs including CD-Recordables (CD-R) and CD-Rewritables (CD-RW). 1 MP3, CD-ROM, CD-I, CDV,VCD, DVD or computer CDs are not possible for playback. 2 IMPORTANT! CDs encoded with copyright protection technologies by some record companies may be unplayable by this product. 1 Adjust the Source selector to CD. 2 Open the CD door, and insert a CD with the printed side facing up, then press the CD door gently to close.
CD Player Different play modes: REPEAT and SHUFFLE (See 6, 7) Reviewing the program In the stop position, press PROG repeatedly to see your stored tracks. REPEAT You can play the current track or the whole disc repeatedly, and combine REPEAT modes with PROGRAM. Erasing a program You can erase the contents of the memory by: – in the stop position, press PROG to enter program mode, and then press 9; – selecting TUNER or TAPE/OFF sound source; – opening the CD door. – plays the current track continuously.
Cassette Recorder Cassette playback 1 Adjust the Source selector to TAPE. 2 Press STOP•OPEN 9/ to open the cassette holder and insert a cassette, and close the deck. 3 Press PLAY 1 to start playback. 4 To pause playback, press PAUSE 8. To resume, press the key again. 5 To stop the tape, press STOP•OPEN 9/. 1 2 Fast forwarding/rewinding Press F.FWD 5/REW 6 until you reach your desired passage. Press 9/ to stop fast forwarding/rewinding.
Maintenance & Safety (See 8) CD player and CD handling • If the CD player cannot read CDs correctly, use a cleaning CD to clean the lens before taking the set to repair. • The lens of the CD player should never be touched! • Sudden changes in the surrounding temperature can cause condensation on the lens of your CD player. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates.
Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. Problem – Possible cause • Remedy No sound /power – • – • – • – • Volume not adjusted. Adjust VOLUME.
Environmental information All unnecessary packaging material has been omitted.The packaging can be easily separated into three materials: cardboard, polystyrene and plastic. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment.
Meet Philips at the Internet http://www.philips.
