Register your product and get support at www.philips.
1 Important Safety Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• Remove batteries when the unit is not used for a long time. p Apparatus shall not be exposed to dripping or splashing. q Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). r This product may contain lead and mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org.
Recording and playback of material might require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972. Disposal of old equipment and Used batteries Information for Users on Collection and Disposal of Old Equipment and Used Batteries These symbols on the products, batteries, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste.
enjoyment.
l K 3 LIN MP o m n a VOLUME • Adjust volume level b DBB • Turn the bass enhancement on/off c Cassette recorder buttons • Pause play or record • Stop cassette play or record Open the cassette holder / • Fast forward/rewind cassette • Start cassette play • Start cassette record d Display e CD Buttons • Stop CD play Erase a CD program •
f g h i j k l m n o Start or pause CD play / • Select the previous/next track Fast search backward/forward within the current track PROG • Program tracks and browse the program LIFT TO OPEN • Open/Close the CD compartment MODE • Select a play mode: REPEAT or SHUFFLE BAND • Select a wave band LINE-IN • Socket for audio input TUNING +/• Tune to radio stations Telescopic antenna • Improve FM reception AC MAINS~ • Socket for the power cord Battery door Source selector: CD, TUNER, LINE-IN, TAPE/OFF • Select sou
6 x 1.5V R-14/UM-2/C-cell 2 3 Insert 6 x 1.5V R14/UM-2/C-cell batteries with correct polarity (+/-) as indicated. Close the battery compartment. Tip • If you want to save battery life, use the supplied power cord. Connect AC power Warning • Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the Soundmachine. • Risk of electric shock! When you unplug the AC adaptor, always pull the plug from the socket. Never pull the cord.
supply socket. • To switch the Soundmachine off completely, disconnect the power cord from the power supply socket. Tip • To save energy: After use, set the source selector to TAPE/OFF. 4 Use your Soundmachine Play a CD Note • You cannot play CDs encoded with copyright protection technologies. You can play commercially available audio: • CDs • CD-Recordables (CD-R) • CD-Rewritables (CD-RW) 1 2 3 4 Switch the source selector to CD. Lift the lid of the CD compartment.
1 During play, press and hold / . » The CD is played at high speed and with reduced volume. 2 Release / to resume normal play. Tip • When search reaches the end of the last track, the CD stops. Program play sequence You can store up to 20 tracks in the desired sequence. 1 In stop mode, press PROG to start to program play sequence. » [PROG] and [00] are displayed. PROG 2 3 4 5 Press / to select a track. Press PROG to store the track. Repeat steps 2 to 3 to select and store all tracks.
• Repeat the entire CD. ALL • To stop repeat play, press MODE repeatedly until the repeat icon is no longer displayed. Shuffle play You can play all tracks in random order. 1 During play, press MODE repeatedly until the display shows the shuffle icon. • To stop shuffle play, press MODE again. Listen to radio 1 2 3 Switch the source selector to TUNER. Switch BAND to FM or MW. Turn TUNING +/- to find a station.
• To stop the play, press . Find a passage within a tape 1 2 During stop, press / to search for a desired passage in a tape. . To stop fast search, press Record from CD 1 2 3 4 5 6 7 Switch the source selector to CD. Insert a CD with the printed side facing up. If you want to record tracks in the desired sequence, program the desired tracks. Press to open the cassette holder. Insert a blank cassette. Close the holder. Press to start to record.
No power • • • Ensure that the power cord is connected securely. Ensure that there is power at the power supply socket. Ensure that the batteries are installed correctly. No sound • • Adjust the volume. Ensure that the track played is of a compatible format. Display does not function properly./No reaction to operation of any of the controls. 1 2 Disconnect the AC power cord. Connect the AC power cord after a few seconds.
Note • Product information is subject to change without prior notice. Dimensions (Main unit) (W x H x D) 291 x 146 x 243 mm 11.5 x 5.8 x 9.6 inches Weight (Main unit) 1.8 kg 3.8 pound Power supply DC 9V 1.
© 2008 Koninklijke Philips Electronics N.V. All rights reserved.
