tone controls @ IR INFRA RED remote sensor, receives the infra rad signals from the remote control unit, & TUNER button.
» Press button DOWN for more than 0.5 seconds. Then release this button. The frequency on the display now changes continuously until a transmitter of sufficient strength has been found. Repeat this procedure, if it is not the station of your choice. » To une to weak stations briefly press UP or DOWN as often as is necessary for optimum reception, or uni ll you read the correct frequency. » If there is interference noise during FM stereo reception, set bunion 3 to the MONO position.
Reverse mode « Set MODE switch @) o ¢ for continuous playback of both sides of the cassette in deck I + Set MODE switch @ to 723 for playback of both sides of fhe cassette in deck I, afire which the tape stops at the end of the second side. ® When you select I, the tape stops at the end of each side. ® Select the tape direction for deck & with DIRECTION bunion @. Dubbing Copying from deck I to deck T * Tress the CASSOCK button (8.
