INSTALLATION CONNECTIONS INSTALLATION CONNECTIONS Unpopular all parts, remove any protective Fig. 7 ? material and take care nof to throw away @ Terminal fér FM aerial, 75 ohms e.g. central | 1 any separately packed parts. Fully tighten both record player transit screws [2] (Fig.3) (screw in clockwise direction). This releases the record player and enables it to rest on its springs. {For AS 135 only) Do not place the unit in direct sunlight o close to radiators, heaters, etc. This will prevent over-healing.
CONTROLS ysiBuzg CONTROLS Fig.2 3 POWER ON/QFF switch, for switching the entire unit nonfood, 23 Graphic equalizer lone controls . 2 Dial pointer with on/off indicator. 4y Dust cover for record player. & RAMIFY wave range selector, (8) Al wave range selector (NOT ON ALL VERSIONS). @ STEREO/MONO selector. @ FREQUENCY TUNING conical, for tuning into radio stations, @ FM STEREO indicator: lights up when an FM broadcast in stereo is received and selector 3 is in the STEREO position, VOLUME control.
OPERATION OPERATION SWITCHING ON AND OFF « Use POWER ON/CFF switch (D fo switch on the unit. The on/off indicator @ will fight up. « T switch off, press POWER ON OFF switch @ again. Indicator @) will fade. Note: “To prevent damage first switch off the record payer of tape decks, The record player: by moving lever [3] to the ¥ position and then moving the tone arm outwards. When the arm reaches the support, the turntable will stop. The tape decks: by pressing the STOP/ EJECT button once.
OPERATION us)bus CASSETTE RECORDING * Recording is only possible with deck i, « For recording, always use NORMAL or FERRY videocassette type I}, * For playback, any cassette type can be inserted. Copyright Recording is permissible insofar as copyright or other rights of third parties are not infringed. Prater the recorder for recording as follows: » Open the cassette compartment & by pressing in EJECTOR & once, if necessary twice.
OPERATION GENERAL INFORMATION DUBBING — Copying from deck I to deck [ * Press TAPE selector &. » Select the dubbing speed with selector &. Do not press this button during dubbing. * Press both EJECTOR buttons and insert a recorded cassette into deck land a cassette which is suited for recording into deck I, Press in PAUSE button . * Press in the RECORD button 3.
MAINTENANCE MAINTENANCE yspfug L Maintenance of the record player The record player requires tattie maintenance because serif-lubricating bearings are used. Replacing the stylus carrier The stylus unit can completely be removed and replaced {see Fig. 7 and 8). Carefully press down the front edge of the stylus carder untie it is released. Support the cartridge wheels pressing. Remove the released career from the cartridge by macing it further downwards.
