Operation Manual

Power Supply General Operation/ Radio
Using AC power
1 Connect the power cord to the
AC INPUT inlet and the wall socket.The
set is now connected and ready for use.
2 To switch the set off completely, withdraw the
power cord from the wall socket.
3 Install the unit near the AC outlet and where
the AC power plug can be easily reached.
• Disconnect the power cord from the wall
socket to protect your set during heavy thun-
derstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.
Helpful hints:
To avoid unnecessary energy
consumption, always adjust the Source selec-
tor to TAPE (OFF) after using the set. Also
check that the tape deck keys are released.
The type plate is located on the
bottom of the set.
General operation
Switching on and off and selecting
functions
1 To switch on, push the
Source selector
slider to TAPE or RADIO as desired.
2 To switch off, push the Source selector to
TAPE/OFF and check the cassette keys are
released.
Helpful hints:
– To change from TAPE to RADIO , or when
you are switching off the set: first make sure
you press the STOP•EJECT 9/ key to end
playback and all the cassette keys are released.
Adjusting volume
Adjust the volume with the VOLUME
control.
Radio reception
1 Adjust the Source selector to RADIO.
2 Adjust the Band selector to select your
desired waveband, MW, SW1, SW2 or
FM.
3 Tu r n TUNING to tune to a station.
- FM STEREO lights up when receiving
stereo FM reception.
- When receiving SW,you may also use
FINE TUNING rotary to fine tune to a
station.
4 To switch off the radio, adjust the Source
selector to TAPE (OFF) position.
To improve radio reception:
• For FM, SW2, extend and turn the tele-
scopic antenna for best reception. Reduce its
length if the signal is too strong.
• For MW, SW1, the set uses a built-in
antenna. Direct this antenna for best recep-
tion by turning the whole set.
AQ7170-61_CCR 2007.9.20 13:58 Page 4