AQ7170-61_CCR 2007.9.20 13:58 Page 1 Stereo Radio Cassette Recorder Register your product and get support at www.philips.
AQ7170-61_CCR 2007.9.
AQ7170-61_CCR 2007.9.20 13:58 Page 3 English Controls/ Power Supply Congratulations on your purchase and welcome to Philips! To fully benifit from the support that Philips offers, register your product at www.philips.com/welcome. Supplied Accessories – AC power cord Top and front panels (See 1) 1 Cassette recorder keys (Cassette A): PAUSE ; – pauses playback or recording STOP•EJECT 9/ – stops playback or recording. – opens the cassette holder. F.
AQ7170-61_CCR 2007.9.20 13:58 Page 4 Power Supply General Operation/ Radio Using AC power General operation 1 Connect the power cord to the AC INPUT inlet and the wall socket.The set is now connected and ready for use. 2 To switch the set off completely, withdraw the power cord from the wall socket. 1 3 Install the unit near the AC outlet and where the AC power plug can be easily reached. Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms.
AQ7170-61_CCR 2007.9.20 13:58 Page 5 Cassette Recorder Tape operation/recording Playing a tape (Cassette A or B) 1 Push the Source selector to TAPE. 2 Press STOP•EJECT 9/ to open the cassette holder and insert a cassette and close the deck. 3 Press PLAY 1 to start playback. 4 To pause playback press PAUSE ; . To resume, press the key again. 5 By pressing F.F/REW 5 or 6, fast forwading/ rewinding of the tape is possible in both directions.To stop fast winding, press 9//.
AQ7170-61_CCR 2007.9.20 13:58 Page 6 Cassette Recorder Recording your voice (Cassette B only) Select TAPE source. • 2 Follows steps 3-4 under Recording from the Radio. Simultaneously press 9 / / on the Cassette A and Cassette B. • 3 Speak towards the built-in microphone MIC located on the top panel. Recording will auto stop when Tape B comes to the end earlier. • • Your voice is recorded. 4 Follows steps 5-6 under Recording from the Radio.
AQ7170-61_CCR 2007.9.20 13:58 Page 7 Maintenance & Safety Safety information Tape deck maintenance To ensure quality recording and playback of the tape deck, clean parts A, B and C as shown, once a month. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean the deck. 1 Open the cassette holder by pressing 9/. 2 Press 1 and clean the roller C. 3 Press ; and clean the heads A, and the capstan B. 4 After cleaning, press 9/.
AQ7170-61_CCR 2007.9.20 13:58 Page 8 Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
AQ7170-61_CCR 2007.9.20 13:58 Page 9 English Meet Philips at the Internet http://www.philips.
